
Video: Minecraft Redstone: Timer - Super simple! by AverageJoe
How to build it
- Connect Two Hoppers Together
Place two hoppers so that their nozzles face directly into each other. You can do this by placing the first hopper, breaking the block it points into, and shift-clicking the second hopper into the first.
- Place the First Comparator and Torch Block
Place a redstone comparator facing outward from the first hopper. Directly in front of that comparator, place a solid building block with a redstone torch attached to its side, facing toward the second hopper.
- Wire the Locking Repeater
Place a second solid block next to your hoppers and run two pieces of redstone dust alongside the torch so it receives power. Feed that redstone line into a redstone repeater pointing directly into the second hopper.
- Set Up the Output Comparator
Place your second redstone comparator facing outward from the second hopper. Place a piece of redstone dust or your target mechanism (such as a piston or door) in front of it to receive the timed output signal.
- Add Items and Trigger Input
Open the first hopper and insert stackable items according to how long you want the timer to stay active. Attach a button to the circuit to power the first hopper and start the timer cycle.
How it works
This circuit acts as a hopper-based pulse extender using item transfer mechanics and hopper locking:
- Idle State: By default, all items sit in the first hopper. The comparator reading this hopper outputs a signal into the solid block, turning off the attached redstone torch. However, until the circuit is triggered, the first hopper remains locked so items cannot move.
- Activation: Pressing the input button briefly powers the redstone line, unlocking the transfer path so items begin flowing into the second hopper.
- Active Output: As soon as the first item enters the second hopper, the output comparator detects it and turns on your connected piston or device. The items continue transferring until the first hopper is completely empty.
- Reset Cycle: Once the first hopper empties, its comparator turns off. This allows the redstone torch to turn back on, powering the repeater and locking the second hopper while allowing the items to drain back into the starting hopper. When the second hopper empties completely, the output turns off.
Tips & variations
- Adjusting the Duration: You can easily change the timer length by adding or removing items inside the hoppers. Each item adds roughly half a second to the overall cycle time (around 10 items for a 5-second delay).
- Silent Operation: Because this timer only uses hoppers, comparators, and a torch rather than pistons, the timer core operates completely silently.
- Common Mistake: Make sure both hoppers are actually pointing into one another. If one points downward or into a surrounding block, the items will get stuck and the timer will break.
- Output Signal Strength: If only a few items are used, the output comparator will produce a weak signal strength (1 or 2). Place a repeater after the output comparator if you need to run a long redstone wire to your door or machine.





