Compact Long Delay Timer

A long delay timer allows you to trigger redstone mechanisms after a significant waiting period without stringing together massive lines of repeaters. This updated design reduces the overall volume to 400 blocks (10x5x8) by flattening the top monostable circuit. It is ideal for automated farms, cooldown systems, and adventure map traps that need either a continuous signal or a quick pulse output.

ClocksIntermediateJava Edition
Compact Long Delay Timer video tutorial

Video: Minecraft - Long Delay Timer (reduced size) by KMBK

How to build it

  1. Clear the 10x5x8 Build Area

    Prepare a workspace that is 10 blocks wide, 5 blocks high, and 8 blocks deep. This updated footprint is one block wider than the older revision, allowing the entire mechanism to fit inside a 400-block volume.

  2. Assemble the Core Delay Mechanism

    Construct the main body of the long delay timer within the 10x8 base. Keep all wiring and logic components at or below the 5-block height limit.

  3. Build the Flattened Monostable Circuit

    Instead of building the monostable pulse circuit sticking two blocks out the top, route it laterally along the side. This adds one block to the overall width of the build while eliminating the two protruding top blocks.

  4. Choose and Wire Your Output Line

    Connect your destination contraption to one of the three output points depending on what signal you need. Tap directly off the primary output torch for a continuous active signal, place a repeater coming off the secondary torch for a short pulse, or wire into the side redstone dust line for a continuous signal while the timer is off.

How it works

This circuit modifies a traditional long delay timer by relocating its monostable circuit (pulse limiter) from the top of the build to the side. While this expands the width by 1 block, it lowers the ceiling by 2 blocks, shrinking the bounding box from over 500 blocks down to exactly 400 blocks (10x5x8).

  • Continuous Active Output: Taken directly from the primary indicator redstone torch while the timer runs.
  • Pulse Output: Taken by placing a redstone repeater facing away from the pulse torch, which fires a brief signal when the cycle stops.
  • Inverted Continuous Output: Taken from the resting redstone wire line, providing power whenever the timer is in its off state.

Tips & variations

  • Select the Right Output: Make sure to use the repeater output if you are triggering dispensers or pistons that only need a brief pulse rather than a locked signal.
  • Height Clearance: Because the top monostable blocks have been tucked into the side, this version easily fits inside standard 5-block-tall underground rooms or between floor layers in a base.

Frequently asked questions

What are the exact dimensions of this reduced long delay timer?
The circuit is 10 blocks wide, 5 blocks high, and 8 blocks deep, for a total volume of 400 blocks.
How do I get a short pulse instead of a constant signal from the timer?
Place a redstone repeater facing out from the output torch so it only transmits a single pulse when the timer finishes.
What changed compared to the older version of this timer?
The monostable circuit that previously stuck up two blocks above the top was moved to the side, making the build one block wider but two blocks shorter.

Components used

More long delay timer