
Video: Minecraft Redstone Update: Edge Detectors and Pulse Normalizer by skaterzero807
How to build it
- Split the Input Signal
Place your input lever on a solid block and run redstone dust out of it, splitting the line into two parallel branches: an immediate path (Signal A) and a delayed path (Signal B).
- Build the Rising Edge Detector
On the immediate path (Signal A), place a solid block with a redstone torch on it to invert the signal. On the delayed path (Signal B), place one or more redstone repeaters, then merge both paths into a final solid block holding your output redstone torch.
- Build the Falling Edge Detector
Start with the same split input, but swap the inverter onto the delayed branch. Run the delayed repeaters into a block with a redstone torch, merge that torch's output with the un-inverted immediate path into a block, and place your final output torch on the front.
- Adjust the Edge Pulse Duration
Right-click the repeaters on the delayed branch to adjust their tick delay, or add more repeaters in series. More repeater delay creates a longer output pulse, while a single 1-tick repeater produces a very quick pulse.
- Build the Dual Edge Detector (XOR Gate)
To detect both rising and falling changes, construct a compact comparator XOR gate and wire your immediate path into Input A and your repeater-delayed path into Input B. Whenever the lever flips either way, the two inputs briefly differ and fire a pulse.
- Set Up the Pulse Normalizer Latch
Build a standard RS NOR latch using two solid blocks and redstone torches, and wire its main output to your door or device. Split your incoming pulse (from a button or edge detector) into two paths leading toward the latch.
- Wire the Set and Delayed Reset Lines
Connect the immediate branch of the input directly to the Set side of the RS NOR latch so the output turns on right away. Run the second branch through a chain of repeaters (as long as you want the door to stay open) and connect the end to the Reset side of the latch.
How it works
All three edge detectors rely on comparing a live input signal against a time-delayed copy of that same signal:
- Rising Edge Detector: When the input is OFF, the inverted immediate path is ON, keeping the final output torch OFF. When you flip the lever ON, the immediate torch turns OFF right away while the repeater branch is still temporarily OFF. With neither branch powering the final block, the output torch flashes ON until the ON signal finishes traveling through the repeaters.
- Falling Edge Detector: Here, the delayed path is inverted instead. While the input is ON, the immediate path holds the final output torch OFF. When you flip the lever OFF, the immediate line drops immediately, while the repeaters briefly keep the delayed inverter torch OFF. The final output torch pulses ON until the OFF state reaches the delayed torch and lets it turn back ON.
- Dual Edge Detector: Both branches feed into an
XORgate, which only outputs power when its two inputs are different. Flipping the lever either ON or OFF changes the immediate input first, creating a temporary mismatch with the delayed branch and emitting a pulse until the repeaters catch up. - Pulse Normalizer: The incoming pulse splits to immediately Set an RS NOR latch (turning the output ON) while simultaneously entering a repeater delay line. Once the signal finishes crossing the repeaters, it hits the Reset input of the latch, turning the output back OFF for a guaranteed fixed duration.
Tips & variations
- Combining Circuits: Rather than adding dozens of repeaters inside an edge detector to get a long pulse (which can cause signal overlap bugs if toggled quickly), set the edge detector to a single 1-tick repeater and feed its output into the pulse normalizer.
- Alternative Dual Edge Detector: If you don't have Nether Quartz for comparators to build the XOR gate, you can build a rising edge detector and a falling edge detector side-by-side and simply connect (OR) their output torches together.
- Ultra-Long Normalizer Delays: For multi-minute pulses without massive repeater chains, replace the repeater delay line with a minecart traveling down a track to a detector rail, or a dispenser dropping a junk item onto a wooden pressure plate (which resets the latch after the 5-minute item despawn timer).





