Falling Edge Detector

A falling edge detector is a vital redstone pulse circuit that remains completely silent while receiving a constant input signal, only firing a short output pulse the exact moment the input turns off. This simple observer-based design is perfect for triggering traps, automated farm sequences, or Piston doors when a lever, pressure plate, or button deactivates.

Pulse CircuitsBeginnerJava Edition
Falling Edge Detector video tutorial

Video: How to Build a Falling Edge Detector in Minecraft! by Mr. Technician

How to build it

  1. Run the Input Redstone Line

    Place your input trigger, such as a lever, and run a line of redstone dust out from it along the ground.

  2. Place the Upward Sticky Piston

    At the end of your redstone dust line, place a sticky piston facing straight up so that the dust powers it directly.

  3. Position the Output Repeater

    On the opposite side of the sticky piston from the input dust, place a redstone repeater on the ground facing away from the piston.

  4. Attach the Observer

    Place an observer directly on top of the sticky piston's head. Make sure the observer's detecting face is pointing back toward the input redstone dust and its red output dot is facing toward the repeater side.

How it works

This circuit relies on moving an observer into and out of alignment with an output line:

  • Rising Edge (Input Turns On): When you flick the lever on, the redstone dust powers the sticky piston. The piston immediately pushes the observer one block upward. Even though the observer sees the dust change state, it is already pushed up and out of alignment with the ground-level repeater before it can send power through it.
  • Active State: While the lever stays on, the sticky piston remains extended, holding the observer up in the air with no output connected.
  • Falling Edge (Input Turns Off): When the lever is switched off, the redstone dust depowers. The sticky piston immediately retracts, pulling the observer back down to ground level. Moving the observer triggers a 1-redstone-tick pulse from its back, which travels directly into the redstone repeater waiting at the bottom.

Tips & variations

  • Observer Orientation: The easiest mistake when building this is placing the observer backward. Double-check that the small red dot on the back of the observer points directly toward your output repeater.
  • Adjusting Pulse Length: The observer outputs a very brief pulse. If the mechanism you are powering needs a slightly longer signal, simply click the output redstone repeater to increase its tick delay.
  • Compactness: You only need a single piece of redstone dust between your input trigger and the sticky piston for the circuit to function properly.

Frequently asked questions

What is a falling edge detector used for in Minecraft?
It converts the turn-off moment of a long signal (like a lever being switched off or a player stepping off a pressure plate) into a quick button-like pulse.
Why isn't my repeater lighting up when I turn the lever off?
Your observer is likely facing the wrong way. Make sure the arrow on top of the observer points toward the repeater and the face points toward the redstone dust.
Can I use a regular piston instead of a sticky piston?
No, you must use a sticky piston so that it pulls the observer back down to the ground when the input power is turned off.

Components used

More edge detector