Instant Edge Detector

An edge detector outputs a brief pulse whenever an input signal turns on or off. This classic technical design uses a unique redstone wire update mechanic where a weak signal blocks a stronger one until a nearby block update forces the dust to recalculate. It is ideal for instant-wire setups and advanced technical contraptions that cannot afford standard repeater delay.

Pulse CircuitsAdvancedJava Edition
Instant Edge Detector video tutorial

Video: Minecraft Redstone Instant Edge Detector by Ray57a

How to build it

  1. Lay the Strong Signal Line

    Place an input lever and run a line of redstone dust toward your output repeater. Make the line long enough that it normally powers the repeater when the lever is turned on.

  2. Add the Weak Blocking Signal

    Run a second, longer line of redstone dust from a steady power source so that it intersects the main line at a lower signal strength. Under specific update order conditions, this weaker signal temporarily prevents the stronger signal from passing through to the output.

  3. Wire the Trigger Input

    Connect your main trigger switch to the intersection point. Flipping this switch either on or off causes a block update next to the intersection, forcing the redstone wire to recalculate and instantly send power into the output repeater.

  4. Build the Piston Reset Loop

    Branch the output line off into a repeater (delayer) leading to a piston holding a solid block over the blocking wire. When the edge is detected, the delayed signal briefly activates the piston to cut and re-establish the blocking signal, resetting the detector into a short pulse.

How it works

This circuit relies on a classic quirk in how Minecraft Java Edition calculates redstone dust signal strength and block updates:

  • Signal Blocking: A weak redstone signal intersecting a line can prevent a newly powered strong signal from propagating down the wire until an adjacent block update occurs.
  • Instant Edge Detection: Toggling the trigger input updates the neighboring redstone dust. The wire immediately realizes it has a stronger power source available and lets the signal rush into the output repeater with zero delay on the trigger edge.
  • Piston Reset: Once triggered, the blocking signal must be refreshed to prepare for the next edge. The output signal splits into a delayed repeater line that pulses a piston, briefly breaking and reconnecting the weak signal line to generate a clean two-tick output pulse.

Tips & variations

  • Historical Mechanic: This design relies on old Java Edition redstone dust update order and directional wire quirks. In modern versions of Minecraft, standard redstone dust updates more consistently, so players usually build instant dual-edge detectors using pistons, redstone blocks, or observers instead.
  • Reset Timing: Make sure the repeater leading to the reset piston has enough delay so the output pulse isn't cut off too early, allowing the piston to open and shut cleanly.
  • Java Only: Because it exploits specific redstone wire update propagation, this circuit will not work on Bedrock Edition.

Frequently asked questions

What is an instant edge detector in Minecraft?
An instant edge detector is a pulse circuit that outputs a short redstone pulse the exact tick an input turns on (rising edge) or off (falling edge), without adding repeater or torch delay to the trigger.
Why does the circuit need a piston?
Once the block update lets the strong signal through, the wire stays powered. The piston briefly cuts and restores the signal path so the blocking state is re-established as a fresh signal for the next toggle.
Does this detect both rising and falling edges?
Yes, flipping the input switch either on or off causes a redstone update at the intersection, detecting both edges instantly.

Components used

More edge detector