
Video: Minecraft - Compact Long Delay Circuit by CobblestoneAndDirt
How to build it
- Place the Hopper Pair
Mark out a 2x3 build area. On one side, place two hoppers facing directly into each other so items can transfer back and forth between them.
- Add the Vertical Droppers
Next to the hoppers, place one dropper on the ground facing straight up. Crouch and place a second dropper directly on top of it facing straight down into the bottom dropper.
- Load the Bottom Dropper
Open the bottom dropper and place exactly one single item inside. Any random item will work for this memory latch.
- Place the Top Comparator and Torch
Place a solid building block next to the bottom dropper so it sits flush with the top dropper. Place a redstone comparator on top of that block reading outward from the top dropper, running into another solid block with a redstone torch attached to its side.
- Add the Hopper Comparator
On the ground level, place a second redstone comparator reading out from one of the hoppers.
- Install the Observer Chain
Place your first observer so its face is looking directly at the ground-level comparator to detect when it changes state. Then, place a second observer above it looking downward at the first observer, with its output pointing toward the top dropper.
- Place the Redstone Dust
Place a piece of redstone dust on top of the observer to route the reset pulse into the top dropper. Depending on your directional orientation in the world, you may also need a dust dot directly on top of the top dropper.
- Set Delay and Test
Add your timing items (for example, 16 items) into the hopper being held locked by the redstone torch. Attach a button to the side of the bottom dropper as your input and place a redstone lamp at the top comparator output to test the extended signal.
How it works
This circuit acts as a resettable timer by combining a vertical dropper RS-NOR latch with a single-torch hopper timer:
- Idle State: The single item rests in the bottom dropper. The top comparator reads nothing, leaving the side redstone torch turned ON. This torch locks the adjacent hopper so all your timing items sit safely in one hopper while the opposite hopper stays empty.
- Triggering the Circuit: Pressing the input button powers the bottom dropper, shooting its single item up into the top dropper.
- Extending the Signal: The top comparator detects the item and turns ON (powering your output lamp) while simultaneously turning OFF the redstone torch. With the torch off, items begin draining from the first hopper into the second hopper beneath the observer chain.
- Resetting: Once the final item drains out of the monitored hopper, its comparator turns off. The first observer detects this state change and triggers the second observer, which sends a quick redstone pulse into the top dropper. The single item shoots back down to the bottom dropper, turning off the main output and relighting the torch so the hoppers refill for the next activation.
Tips & variations
- Adjusting the Delay: Add more stackable items into the hopper to increase the pulse duration, or remove items for a shorter pulse.
- Directional Quirks: Dropper update order and quasi-connectivity can behave slightly differently depending on which compass direction you build the circuit. If the top dropper fails to reset, try adding or removing a piece of redstone dust directly on top of the top dropper.
- Input Powering: Powering the bottom dropper cleanly is important so you do not accidentally trigger the top dropper at the same time. A button attached directly to the bottom dropper or a redstone torch mounted on its side provides the most reliable input; avoid running high-strength dust lines or repeaters straight into it if they cause interference.





