
Video: Compact Pulse Extender | Adjustable & Silent by Cortezerino
How to build it
- Place the Input Block and Comparator
Place a solid block on the ground to act as your input block and attach a button to it (or run your input line into it). Place a Redstone Comparator directly behind this block, facing into it.
- Set Up the Hopper Loop
Behind the comparator, place two hoppers facing directly into each other. To do this, place a temporary hopper, crouch-place the second hopper into the side of it, then break the first hopper and reconnect it so its nozzle points back into the second one.
- Add the First Torch and Second Block
Attach a Redstone Torch to the side of your first input block (on the side adjacent to the comparator). Next, place your second solid building block directly next to the comparator, right in front of that torch.
- Place the Output Torch and Redstone Dust
Attach your second Redstone Torch to the side of the second solid block so it sits right next to the back hopper; this torch is your output. Finally, place two pieces of Redstone Dust: one on top of the second solid block, and one on the ground next to the comparator and front hopper.
- Load Items to Set the Duration
Open the hopper directly behind the comparator and insert stackable items. Use around 15 items for a short pulse, or add more stacks to extend the timer up to nearly five full stacks.
How it works
This circuit relies on locking and unlocking two hoppers that feed into each other, combined with comparator side-input logic:
- Resting State: The redstone torch on the input block is ON. It powers the second solid block and the two pieces of redstone dust. Because the second block is powered, the output torch attached to it stays OFF.
- Hopper & Comparator Lock: The powered redstone dust next to the front hopper locks it, preventing any items inside from moving into the back hopper. At the same time, the powered dust runs into the side of the comparator with a signal strength of 14, cancelling out the comparator's reading so it stays OFF.
- Triggering the Pulse: Pressing the button powers the input block and turns OFF the first torch. The redstone dust unpowers, which unlocks the front hopper and removes the side signal blocking the comparator. Simultaneously, the second block unpowers, turning ON the output torch.
- Extending the Signal: The output torch now locks the back hopper while items trickle out of the front hopper into the back one. Because the side dust is off, the comparator reads the items remaining in the front hopper and keeps the input block powered, holding the first torch OFF even after the button pops back out.
- Resetting: Once the final item leaves the front hopper, the comparator turns OFF. The first torch turns back ON, the output torch turns OFF (unlocking the back hopper), and all items flow back into the front hopper to reset for the next use.
Tips & variations
- Do Not Overfill: Never fill the hopper completely full with 5 full stacks (320 items). Leave at least one item out of the fifth stack (max 319 stackable items). If the hopper is 100% full, it outputs a signal strength of 15, which overpowers the signal strength of 14 coming from the side redstone dust and breaks the circuit.
- Reading the Output: Take your output signal from the second redstone torch (the one adjacent to the back hopper). It remains OFF while idle and turns ON for the duration of the extended pulse.
- Reset Time: Keep in mind that after the output turns off, the items need the same amount of time to drain back into the front hopper before the full duration is ready again.





