Button Pulse Extender

Standard buttons in Minecraft only emit a brief redstone pulse, which is often too short to cross a hidden bridge or walk through a distant door. This circuit uses a simple memory latch paired with a repeater delay line to keep your output powered for as long as you need. Once the delay finishes, the circuit automatically resets itself.

Pulse CircuitsBeginnerJava Edition
Button Pulse Extender video tutorial

Video: Minecraft Tutorial - Make A Button Keep Redstone On For As Long As You Want by Jallenbah

How to build it

  1. Build the Memory Latch

    Place two solid blocks on the ground with a small gap between them. Attach a redstone torch to the side of each block so the torches face each other, and run redstone dust between them so that one torch powers the opposite block and turns the other torch off.

  2. Wire the Button Input

    Place your button and run a line of redstone dust directly into the block holding the currently lit redstone torch. Pressing the button will invert the latch, turning the first side off and keeping the second side on indefinitely.

  3. Connect Your Output Device

    Run a redstone dust line from the second side of the latch (the side that turns on when the button is pressed) to a piston, door, or bridge mechanism.

  4. Add the Repeater Reset Line

    Branch a second line of redstone dust off your main button wire and route it through a chain of redstone repeaters. Connect the end of this repeater chain into the second block of the latch so the delayed signal automatically resets the circuit and turns your output off.

How it works

This pulse extender relies on a classic 1-bit memory circuit known as an RS NOR Latch paired with a timed reset line:

  • Setting the Latch: In its resting state, one side of the latch is ON while the output side is OFF. Pressing the button sends an immediate pulse into the first block, turning its redstone torch off.
  • Holding the State: Because the first torch turns off, it stops powering the second block. The second block's torch turns ON, powering your piston or output device and locking the first torch in the OFF state even after the button pops back out.
  • Timed Reset: At the exact same time you press the button, the signal splits into a long chain of redstone repeaters. After traveling through all the repeaters, the delayed pulse reaches the second block, turning its torch back off and resetting the latch to its original state.

Tips & variations

  • Adjusting the Duration: You can make the output stay on for as long as you want by right-clicking the repeaters to increase their tick delay or simply adding more repeaters to the reset chain.
  • Common Mistake: Make sure all repeaters in the delay chain are facing away from the button and toward the reset block of the latch, otherwise the reset signal will never arrive.
  • Compact Alternative: In newer versions of Minecraft, you can also build a compact pulse extender using two side-by-side loops of redstone comparators, though this repeater-latch design allows for massive, exact delays without needing Nether Quartz.

Frequently asked questions

How do I make the button stay on even longer?
Simply extend the reset wire and add more redstone repeaters set to their maximum 4-tick delay before the line reaches the reset side of the latch.
What is the memory part of this circuit called?
The two-block, two-torch memory unit is called an RS NOR latch. It holds a 1-bit state (on or off) indefinitely until a signal enters the opposite side to reset it.
Why does my piston stay extended forever?
If the piston never retracts, your repeater delay line is not properly powering the reset block. Check that every repeater is facing the right direction and that the final dust or repeater runs directly into the block holding the active torch.

Components used

More pulse extender