Repeater Clock

A redstone repeater clock creates an infinite loop of redstone pulses that repeats continuously until broken. This basic circuit is ideal for players who need to constantly trigger pistons, dispensers, or other automated mechanisms in their survival worlds.

ClocksBeginnerJava Edition
Repeater Clock video tutorial

Video: Minecraft Redstone Repeater Infinite Loop Tutorial 1.18.2 (2022) by CowPunFun

How to build it

  1. Arrange the Repeaters in a Loop

    Place your redstone repeaters on the ground so they form a circular path, with each side facing the next in a single direction around the loop. Increase the tick delay on the repeaters so they are opened all the way up.

  2. Connect the Corners with Redstone Dust

    Place redstone dust at the open corners between the repeaters to link the outputs into the next inputs, completing the closed circuit.

  3. Pulse the Circuit with a Redstone Torch

    Place a redstone torch next to one of the redstone dust corners and immediately break it to inject a short pulse into the loop.

  4. Attach Your Mechanism

    Connect a piston or another redstone device to the outside of the dust corners to have it activate repeatedly as the signal travels around.

How it works

This circuit works by trapping a short redstone pulse inside a closed directional loop:

  • Directional Flow: Redstone repeaters only allow a signal to pass from their back (input) to their front (output). Arranging them in a circle forces the signal to travel continuously around the loop.
  • Signal Delay: Opening the repeaters to their maximum tick delay slows the signal down. This ensures that the first corners turn off before the signal makes a full trip back around.
  • Starting Pulse: Quickly placing and breaking a Redstone Torch introduces a brief pulse. If the power source were left in place, the whole loop would stay permanently powered instead of flashing on and off.

Tips & variations

  • Common Mistake (Locked Loop): If you break the redstone torch too slowly, the signal will fill the entire loop and stay solid on. To fix this, break one piece of redstone dust to clear the power, replace the dust, and tap the torch faster, or make sure your repeaters are set to a slower delay.
  • Adjusting Speed: You can change how fast your piston fires by adjusting the delay ticks on the repeaters or by adding more repeaters to make the loop larger.
  • Check Orientation: If the pulse stops partway through, double-check that every repeater is pointing the same way around the circle (all clockwise or all counter-clockwise).

Frequently asked questions

Why did my repeater loop stay completely lit up instead of flashing?
The redstone torch was left down for too long, or the repeater delays are set too fast. Break one piece of redstone dust to reset the loop, set the repeaters to their maximum delay, and break the torch immediately after placing it.
How do I stop the infinite repeater loop?
Simply break any piece of redstone dust in the corner to interrupt the circuit, or place a constant power source (like a lever or torch) next to the dust to lock the line on.
What can I power with this repeater clock?
You can attach pistons, sticky pistons, dispensers, droppers, note blocks, or redstone lamps to any of the redstone dust corners to trigger them continuously.

Components used

More repeater clock