
Video: Minecraft Redstone Clock Tutorial by CandyCrazy
How to build it
- Design 1: Start the Repeater Loop
Place a solid block on the ground and attach a button to one side. Behind the block, place a piece of redstone dust to catch the button's signal.
- Arrange the Repeaters in a Circle
Place redstone repeaters in a continuous square or circular loop leading away from the first dust, making sure each repeater faces into the next corner. Place one piece of redstone dust at each of the four corners to connect the sides.
- Set the Delay and Activate
Adjust the repeaters to your desired tick delay (such as 3 ticks) depending on how slow you want the pulse to travel. Press the button to inject a pulse into the loop and start the clock.
- Design 2: Place Blocks for the Classic Torch Clock
If you do not have repeaters, place an odd number of solid blocks (at least three or five) spaced apart in a large loop. Attach a redstone torch to the forward-facing side of each block.
- Wire the Torch Loop Together
Run a trail of redstone dust from each redstone torch into the back of the next solid block in the circle. Once you connect the final torch back to the first block, the torches will begin cycling on and off around the loop.
- Design 3: Build the Compact Hybrid Clock
For the smallest and most reliable design, place a single solid block on the ground and attach a redstone torch to one side. Place a redstone repeater directly next to the torch, facing away from the block region so the torch powers it.
- Set the Delay and Loop the Dust
Set the repeater to at least 3 ticks of delay so the torch does not burn out. Finally, run a small loop of redstone dust from the output of the repeater right back into the solid block holding the torch to start the clock.
How it works
Each of these three clocks generates a repeating signal using a continuous feedback loop:
- Repeater Loop Clock: Pressing the button sends a pulse into the ring of repeaters. Because repeaters only pass power in one direction with a short delay, the pulse chases its own tail endlessly around the corners.
- Classic Torch Clock: Redstone torches invert the signal of the block they are attached to. With an odd number of torches wired in a circle, each torch turns off the next one in line, creating a domino effect that ripples continuously around the track.
- Compact Torch-Repeater Clock: The redstone torch starts in an
ONstate and powers the repeater. After the 3-tick delay set on the repeater, the signal travels through the redstone dust back into the solid block, which turns the torchOFF. Once the torch turns off, the repeater loses power, the block unpowers, and the torch turns backONto repeat the cycle.
Tips & variations
- Preventing Torch Burnout: In both torch-based clocks, cycling a redstone torch too quickly causes it to hiss and temporarily burn out. Always set the repeater in the third design to at least 3 ticks, or add extra repeaters/torches to slow the cycle down.
- Expanding the Hybrid Clock: If you need a longer delay on the third design, simply extend the line with additional repeaters before looping the redstone dust back into the block.
- Adding an Off Switch: You can easily pause any of these clocks by placing a lever on one of the solid blocks (or next to a piece of corner redstone dust) and flipping it on to lock the signal.





