Basic Redstone Clock

A basic repeater clock generates an endless, steady loop of redstone pulses without needing constant player interaction. It is one of the most foundational circuits in Minecraft, ideal for powering automatic dispensers, flashing lights, note block loops, and simple survival farms.

ClocksBeginnerBedrock Edition
Basic Redstone Clock video tutorial

Video: How To Make a Redstone Clock In Minecraft Bedrock! - Tutorial by FryBry

How to build it

  1. Arrange the Repeaters in a Circle

    Place four redstone repeaters on the ground as the four sides of a small square, leaving the four corner blocks empty. Rotate as you place them so that each repeater points clockwise (or counter-clockwise) into the next corner.

  2. Connect the Four Corners

    Place one piece of redstone dust on each of the four empty corner blocks to wire all four repeaters together in a continuous loop.

  3. Set the Repeater Delays

    Interact with each of the four repeaters to pull its movable torch all the way back to the maximum 4-tick delay setting.

  4. Jump-Start the Clock

    Place a redstone torch next to any one of the four redstone dust corners and immediately break it. This injects a short pulse that will begin cycling infinitely around the repeater loop.

How it works

This circuit works by trapping a short redstone pulse inside a closed directional loop:

  • Signal Injection: Placing and quickly breaking the Redstone Torch next to a corner dust creates a brief pulse that enters the first repeater.
  • Delay & Amplification: Each Redstone Repeater set to full delay holds the signal for 4 redstone ticks before passing it at full strength (15) to the next corner's Redstone Dust.
  • Continuous Loop: Because the total delay of the four repeaters is longer than the pulse created by the torch, the corner behind the signal turns off before the signal loops all the way around, allowing the pulse to chase itself forever.

Tips & variations

  • Common Mistake (Locked Clock): If all four corners and repeaters stay permanently lit, you left the redstone torch placed for too long. Break one piece of redstone dust to clear the power, replace the dust, and tap the torch faster.
  • Adjusting the Speed: You can make the clock pulse faster by setting the repeaters to shorter delays (fewer clicks), though faster clocks require an even quicker torch placement and removal to avoid locking up.
  • Taking an Output: Run a line of redstone dust out from any of the four corner dust pieces to power your contraption.
  • Silent Operation: Because this design only uses repeaters and dust, it is completely silent while running.

Frequently asked questions

Why did my repeater clock light up completely and stop blinking?
If you do not break the redstone torch fast enough, the pulse fills the entire loop at once. Break one corner of redstone dust to let the power drain, put the dust back, and place and break the torch much faster.
Why doesn't the signal travel all the way around the loop?
Check the direction of your repeaters. All four repeaters must follow the same circular direction (all clockwise or all counter-clockwise). If one faces the wrong way, it will block the signal.
How do I stop the redstone clock?
Simply break any piece of redstone dust on one of the corners to interrupt the loop, or power one of the corners continuously with a lever so the signal stops flashing.

Components used

More repeater clock