Quick Redstone Clock

A quick redstone clock generates a rapid, repeating on-and-off pulse as long as its input remains active. This simple comparator and repeater loop is ideal for powering automatic trash cans, rapid droppers, blinking lights, or any contraption that needs a constant pulse. Because it is controlled by a lever, you can easily toggle the clock on and off whenever you need it.

ClocksBeginnerJava Edition
Quick Redstone Clock video tutorial

Video: How to build a QUICK REDSTONE CLOCK by Tinker77

How to build it

  1. Place the Control Lever

    Place a lever on the ground to act as your master on/off switch. Leave it switched off (no redstone particles showing) while you assemble the circuit.

  2. Add a Comparator in Subtract Mode

    Place a redstone comparator facing directly away from the lever. Right-click or interact with the comparator to turn on its single front torch, putting it into subtract mode.

  3. Place the First Repeater and Dust

    Directly in front of the comparator's output, place a redstone repeater facing the same direction. Place two pieces of redstone dust leading out from the front of that repeater and turning to the side to begin a loop.

  4. Complete the Feedback Loop

    From the second piece of redstone dust, place a second repeater facing back toward the lever end of the build. Place one more piece of redstone dust in front of this repeater so that it connects directly into the side of the comparator.

  5. Connect Your Output Device

    On the side of the loop with the two redstone dust, place a third redstone repeater facing outward away from the clock. Place a redstone lamp (or other mechanism like a dropper) in front of this repeater, then flick the lever to start the blinking pulse.

How it works

This circuit relies on a Redstone Comparator set to subtract mode to constantly interrupt its own signal:

  • Power Input: Flipping the lever sends a full signal strength of 15 into the rear input of the comparator.
  • Signal Propagation: Because the side input starts at 0, the comparator outputs a signal of 15 into the first repeater, powering the two redstone dust and the second repeater.
  • Subtraction Feedback: The second repeater feeds full power into the final piece of redstone dust entering the side of the comparator. In subtract mode, the comparator calculates Rear (15) - Side (15) = 0, turning its output off.
  • Oscillation: Once the output turns off, the side input loses power a few ticks later due to the repeaters, allowing the comparator to turn back on and repeat the cycle endlessly.

Tips & variations

  • Common Mistake: If the circuit stays solidly lit instead of blinking when you flip the lever, check the comparator—its single front torch must be glowing (subtract mode).
  • Adjusting Speed: You can slow the blinking down by right-clicking the repeaters in the loop to add more delay ticks.
  • Practical Automation: Instead of a lever, you can take a comparator output directly from a dropper or container so the clock automatically runs only when items are inside, which is great for automatic trash disposals.

Frequently asked questions

Why does my clock stay on instead of blinking?
Make sure you interacted with the comparator to turn on its front torch (subtract mode), and ensure the loop feeds into the side of the comparator rather than back into the lever.
How do I turn the redstone clock off?
Simply flip the input lever to the off position (so it stops showing redstone particle effects) to cut power to the comparator.
What can I power with this quick clock?
You can hook the output up to redstone lamps for flashing lights, or connect it to droppers and dispensers for automatic item disposal and trash systems.

Components used

More repeater clock