Infinite Repeater Loop

An infinite repeater loop is one of the simplest redstone clock circuits in Minecraft, sending a continuous pulsing signal forever. You can use this compact circuit whenever you need to fire dispensers rapidly or automate repetitive redstone mechanisms.

ClocksBeginnerJava Edition
Infinite Repeater Loop video tutorial

Video: How To Make A Infinite Repeater Loop In Minecraft - Full Guide by GuideRealm

How to build it

  1. Place the Repeaters

    Place one Redstone Repeater on the ground, then place a second Redstone Repeater right next to it facing the exact opposite direction.

  2. Connect the Loop with Redstone Dust

    Place two pieces of Redstone Dust on either end of the repeaters to connect them together into a closed rectangular circuit.

  3. Power the Circuit

    Place a Redstone Torch next to the redstone dust so the entire loop lights up and becomes fully powered.

  4. Trigger the Infinite Pulse

    Remove the power source or quickly break one piece of Redstone Dust and immediately replace it. If timed right, the signal will begin chasing itself around the loop.

  5. Attach a Mechanism

    Connect a component like a Dispenser loaded with arrows to the pulsing redstone dust to see it fire continuously.

How it works

This circuit is a classic 2-repeater clock. Here is how the signal travels through the loop:

  • Opposing Directions: Because the two Redstone Repeaters face opposite ways and are linked at both ends by Redstone Dust, the output of the first repeater feeds directly into the input of the second repeater, and vice versa.
  • Creating a Pulse: When you power the loop with a Redstone Torch, the entire line locks into an "ON" state. By quickly breaking and replacing a piece of redstone dust, you interrupt the continuous power and shorten it into a brief pulse.
  • Infinite Cycling: As each repeater receives the short pulse, it delays the signal slightly before passing it to the other side, allowing the current to cycle in a circle indefinitely.

Tips & variations

  • Solid Power Lock: If the entire circuit stays glowing and does not blink, you did not break and replace the redstone dust fast enough (or the Redstone Torch is still attached). Remove the torch and try the break-and-replace trick again, or increase the tick delay on the repeaters to give yourself more reaction time.
  • Adjusting Speed: Right-click (or interact with) both repeaters to increase their tick delay if you want a slower, more manageable pulse.

Frequently asked questions

Why is my repeater loop stuck staying on instead of blinking?
If the redstone stays permanently lit, the pulse is too long or the redstone torch is still powering the line. Make sure the torch is removed, then break and replace one redstone dust much faster—or set the repeaters to a higher delay so the timing is easier.
How do I stop the infinite repeater loop?
Simply break any piece of redstone dust in the circuit to cut the connection, or place a constant power source (like a redstone torch or switched-on lever) next to the dust to lock the signal.
What can I power with an infinite repeater loop?
You can attach dispensers to shoot arrows or fireworks rapidly, droppers to eject items automatically, pistons, or note blocks.

Components used

More repeater clock