Compact Toggleable Repeater Clock

A toggleable repeater clock generates a continuous pulsing redstone signal that can be easily switched on and off with a lever. Built in a compact 1-block-wide profile using a redstone torch and repeaters, it is ideal for driving dispensers, note blocks, or automated farms where you need full control over both the pulse speed and activation.

ClocksBeginnerJava Edition
Compact Toggleable Repeater Clock video tutorial

Video: Minecraft 1.3 Compact redstone clock Tutorial {Toggle-able} {Configure-able} by silverkill95

How to build it

  1. Place the Base Block and Dust

    Start by placing one solid block on the ground and putting a piece of redstone dust directly on top of it.

  2. Add the Repeater and Second Block

    Place a redstone repeater leading out from your first block into a second solid block. You can chain multiple repeaters in a row here if you want a slower clock.

  3. Set the Repeater Delay

    If you are building the smallest version with only one repeater, right-click it to set it to at least 2 ticks (the second position). This prevents the redstone torch from burning out.

  4. Attach the Redstone Torch

    Place a redstone torch on the side of the second block facing back toward your starting block, and place redstone dust directly underneath that torch to complete the feedback loop.

  5. Add the Toggle Lever and Output

    Attach a lever to either the block holding the redstone torch or the block with the redstone dust on top to turn the clock on and off. Connect your output line to the positive side of the circuit so it stops pulsing when toggled off.

How it works

This circuit works as a vertical torch-repeater feedback loop:

  • Signal Generation: The redstone-torch powers the redstone-dust directly beneath it, which sends a signal into the first solid block and through the redstone-repeater line.
  • Inversion Loop: After the set tick delay, the repeater powers the block holding the redstone torch. This turns the torch off, cutting power to the dust underneath.
  • Continuous Cycle: Once the repeater loses power, the torch turns back on and repeats the cycle indefinitely.
  • Toggling: Flipping the lever permanently powers the block or dust line, locking the torch in its off state and pausing the clock.

Tips & variations

  • Preventing Torch Burnout: A single repeater on a 1-tick delay switches too fast and causes the redstone torch to burn out. Always keep a total delay of at least 2 ticks in the loop.
  • Extending the Delay: To make the clock pulse slower, simply extend the line with additional repeaters before placing the final block and torch. With multiple repeaters in the chain, individual repeaters can safely be set back to 1 tick.
  • 1-Wide Profile: Because the loop folds vertically over itself, the entire clock is only 1 block wide, allowing you to fit it into tight spaces or build several clocks near each other.
  • Choosing the Output Side: Always take your output from the non-inverted (positive) side of the clock so that turning the lever on cleanly shuts the output off rather than leaving it permanently powered.

Frequently asked questions

Why does my redstone torch keep burning out and smoking?
Your total repeater delay is too short. If you are only using one repeater, set it to at least the second position (2 ticks) so the torch does not cycle fast enough to burn out.
How do I make the clock pulse slower?
You can either right-click the existing repeater to increase its tick delay up to 4 ticks, or make the line longer by chaining multiple repeaters in a row.
Where should I place the lever to toggle the clock?
You can place the lever on the block with the redstone dust on top or directly on the block holding the redstone torch. Both positions will lock the circuit and stop the clock when switched on.

Components used

More repeater clock