Redstone Spiral Clock

A Redstone Spiral Clock creates a continuous, chasing light effect around a square loop of redstone lamps. This simple repeater clock is perfect for decorating floors, ceilings, minigame arenas, or adding dynamic lighting to your survival base. Because the design relies on an alternating pattern, you can easily scale it up or adjust the speed to fit any build.

ClocksBeginnerJava Edition
Redstone Spiral Clock video tutorial

Video: Redstone Spiral Clock Tutorial - Minecraft Tutorial by Farzy

How to build it

  1. Build the Lamp Frame

    Place a line of 5 redstone lamps on the ground, then place 1 solid building block at the corner. Repeat this pattern on all four sides to form a hollow 7x7 square with 5 lamps per side and 4 corner blocks.

  2. Add Corner Redstone Dust

    Place 1 piece of redstone dust on top of each of the 4 solid corner blocks.

  3. Place the Outer Repeaters

    On the redstone lamps directly touching the corner blocks, place redstone repeaters. Make sure all repeaters are facing in the exact same clockwise or counter-clockwise direction around the loop.

  4. Complete the Alternating Loop

    On each side of 5 lamps, place redstone dust next to the two outer repeaters, and place a final repeater on the very middle lamp. Every side should now have an alternating pattern of repeater, dust, repeater, dust, repeater.

  5. Start the Spiral Clock

    Place a temporary block next to one of the corner redstone dust pieces. Place a redstone torch on the side of that block to power the dust, then break the torch immediately to send a short pulse chasing around the loop.

  6. Adjust the Speed (Optional)

    To slow down the chasing light effect, right-click all 12 repeaters once to set them to a 2-tick delay. Avoid setting the delay too high, or the light transitions may look choppy.

How it works

This build works as a basic repeater loop clock placed directly on top of redstone lamps:

  • Signal Propagation: When you briefly place and break the redstone torch, it injects a short redstone pulse into the corner dust.
  • Directional Flow: The repeaters act as one-way diodes, forcing the pulse to travel in a single continuous direction around the square perimeter while adding a slight tick delay at each step.
  • Lamp Activation: Both the repeaters and the redstone dust power the redstone lamps directly beneath them. Because a powered lamp also lightly powers adjacent lamps, a smooth wave of light appears to chase itself around the track indefinitely.

Tips & variations

  • Common Mistake - All Lamps Stay On: If you do not break the redstone torch fast enough, the signal will catch up to its own tail and lock the entire circuit on. To fix this, break one piece of corner dust until all lights turn off, replace the dust, and try pulsing the torch faster.
  • Customizing the Size: You can make this loop much larger or smaller. Simply keep an odd number of redstone lamps on each side so the alternating repeater-and-dust pattern lines up with the corner dust blocks.
  • Speed Control: Leaving all repeaters on their default 1-tick delay creates a very fast spiral, while clicking each repeater once (2-tick delay) gives a smoother, more relaxed animation.

Frequently asked questions

Why did all my redstone lamps stay lit up without moving?
You left the redstone torch placed for too long, filling the entire loop with power. Break one piece of redstone dust to clear the power, place the dust back, and place/break the torch much quicker.
Why did the pulse stop halfway around the square?
One of your repeaters is likely facing the wrong way. Check all 12 repeaters to ensure the arrows on top follow the exact same circular direction.
Can I hide the redstone on top of the lamps?
Yes! If you build this in a ceiling, players looking up from the room below will only see the bottom of the glowing redstone lamps, completely hiding the repeaters and dust on top.

Components used

More repeater clock