Eyeblossom Automatic Day/Night Campfire

This underground redstone contraption uses the 1.21.4 eyeblossom flower to automatically light a campfire at dusk and put it out at dawn. Because the entire mechanism sits beneath the campfire, you can easily hide it under campsites, fireplaces, or decorative outdoor builds in both Java and Bedrock worlds.

Contraptions & GadgetsIntermediateJava & Bedrock
Eyeblossom Automatic Day/Night Campfire video tutorial

Video: Eyeblossom Powered Campfire - Automatic Day/Night Cycle - Minecraft 1.21.4+ Redstone Tutorial by RandyBishop

How to build it

  1. Build the 8-Tick Delay Line

    Start in a corner of your 5x7 area by placing 4 solid blocks in a row with 4 redstone dust on top. Behind that line, place 3 more blocks in an L-shape, topped with two repeaters each set to 4 ticks (8 ticks total) and 1 redstone dust at the corner.

  2. Add the Torch Control Line

    At the end of the reverse-L shape, place a block with a repeater set to 3 ticks. Run 3 solid blocks alongside this repeater with 3 redstone dust on top, and place a solid block directly in front of the 3-tick repeater.

  3. Place the Target Block and Second Pulse Repeater

    Next to the last line of redstone dust, place a block with redstone dust on top, and attach a target block next to it. Use a temporary block to place a raised solid block nearby with a repeater set to 3 ticks pointing toward the target block line, with a block and redstone dust behind it.

  4. Install the Input Repeater and Flower Pot

    Place two raised blocks next to the back dust line using a temporary block, adding redstone dust on the upper block and a repeater set to 2 ticks in the gap between them. Place a solid block behind the 2-tick repeater and set your flower pot on top.

  5. Add the Observer and Redstone Torch

    Place an observer facing directly into the flower pot so its output points into the 2-tick repeater line. Then, squeeze a redstone torch onto the block in front of your lower 3-tick repeater to lock the lower hopper position.

  6. Assemble the Dropper and Dispenser Loop

    Place a dropper facing upward right next to the 8-tick repeater line, and attach a hopper feeding sideways into that dropper (above the redstone torch). Place a dispenser facing upward on top of the lower hopper, and attach a second hopper on top of the dropper feeding sideways into the dispenser.

  7. Load Items and Place the Campfire

    Put the water bucket inside the dispenser and the flint and steel in the lower hopper, then place your campfire on top of the dispenser. Finally, during the daytime, place the eyeblossom into the flower pot—its state change will dispense water to put out the campfire and prime the cycle for nightfall.

How it works

The circuit works by cycling a Water Bucket and a Flint and Steel in a 2x2 ring made of a dispenser, a dropper, and two hoppers, triggered whenever the eyeblossom changes state between day and night:

  • Eyeblossom Detection: At nightfall the eyeblossom opens, and at dawn it closes. The Observer watching the flower pot detects this block update and sends a pulse through a 2-tick repeater into the main redstone line.
  • Double Pulse to Dispenser: The main redstone line directly powers the Target block next to the dispenser (first pulse), and simultaneously runs through a parallel 3-tick repeater to power the target block a second time (second pulse). Two pulses are required when using a water bucket: the first dispenses water to extinguish the campfire, and the second immediately picks the water back up into the bucket. When the flint and steel is inside, it ignites the campfire on the first pulse and ignores the second pulse without losing extra durability.
  • Hopper Unlocking & Item Cycling: The lower hopper under the dispenser is normally locked by a Redstone Torch so the active tool stays inside the dispenser. During an activation, a 3-tick repeater turns off that torch briefly, allowing the item in the dispenser to drop into the lower hopper and enter the dropper while the waiting item moves up to replace it.
  • 8-Tick Dropper Delay: Two 4-tick repeaters (8 ticks total) delay the signal reaching the upward-facing Dropper until the swapped item has arrived, shooting it up into the top hopper which feeds it back into the dispenser for the next day/night transition.

Tips & variations

  • Enchant Your Flint and Steel: A standard flint and steel only lasts 64 ignitions. Applying Unbreaking III before loading it into the hopper will drastically extend how many in-game days the campfire runs maintenance-free.
  • Syncing Day and Night: Because a newly placed campfire always starts lit, wait until daytime to plant the eyeblossom into the pot, or manually remove and re-place the eyeblossom once to invert the cycle if your campfire is lighting during the day and turning off at night.
  • Java & Bedrock Compatibility: This build uses standard repeater timings and a target block to redirect dust into the dispenser, allowing it to work identically in both Java and Bedrock Editions (1.21.4+).

Frequently asked questions

Does the double pulse wear out the flint and steel twice as fast?
No. A flint and steel inside a dispenser only loses durability when it successfully lights the campfire on the first pulse; the second pulse does not consume durability once the campfire is already lit.
Does the eyeblossom need sunlight underground to work?
No, eyeblossoms open and close based on the overworld day/night cycle even when completely enclosed underground beneath your campfire.
Why is my campfire turning on during the day and off at night?
The water bucket and flint and steel are out of sync with the time of day. Simply take the eyeblossom out of the flower pot and put it back in once to advance the cycle by one step.

Components used

More automatic lights