Automatic Motion Sensor Lights

Motion sensor lights automatically illuminate when you walk near them and shut off once you walk away. Using a waterlogged sculk sensor paired directly with a redstone lamp, you can build sleek, silent lighting for street lamps, pathways, and indoor ceilings in both survival and creative modes.

Contraptions & GadgetsBeginnerJava & Bedrock
Automatic Motion Sensor Lights video tutorial

Video: How To Make Automatic MOTION SENSOR LIGHTS In Minecraft Java & Bedrock! by VIPmanYT

How to build it

  1. Build the Lamp Post Base

    Place a decorated pot on the ground and put a fence directly on top of it to create the post. You can customize this support structure using any blocks or walls you prefer.

  2. Attach the Redstone Lamp

    Place a redstone lamp on top of the fence post. If you have trouble clicking directly onto the fence, build a small pillar of temporary blocks next to it, place the lamp against the top block, and break the temporary pillar.

  3. Place the Sculk Sensor

    Put a sculk sensor directly on top of the redstone lamp. It will immediately begin detecting nearby movement and powering the lamp below it.

  4. Surround the Sensor with Stairs

    Place stairs around the four sides of the sculk sensor, making sure the redstone lamp underneath stays visible. These stairs hide the sensor and act as a barrier so water cannot flow out.

  5. Waterlog the Sculk Sensor

    Use your water bucket directly on the sculk sensor to waterlog it. Waterlogging completely silences the sensor's clicking sound while still allowing it to detect your footsteps.

  6. Cap the Light with a Slab

    Place a slab on top of the waterlogged sculk sensor to conceal the mechanism and finish the street lamp design.

How it works

This contraption takes advantage of the Sculk Sensor's ability to detect nearby vibrations and output a redstone signal in all directions:

  • When a player or mob walks within range, their footsteps generate vibrations that travel through the air to the sculk-sensor.
  • Upon receiving a vibration, the sculk sensor activates for a brief cooldown period and emits a redstone signal to every block directly touching it, powering the redstone-lamp touching it.
  • Waterlogging the sculk sensor mutes the clicking noise it normally makes upon activation without disabling its redstone output or vibration detection.
  • Once you stop moving or walk out of detection range, the sensor stops outputting power and the lamp turns off automatically.

Tips & variations

  • Pathway Lights: For ground-level lights alongside a road or path, dig a 1-block hole, place a waterlogged sculk sensor inside, and put the redstone lamp directly on top of it.
  • Indoor Ceiling Lights: Embed redstone lamps into your base's ceiling and place waterlogged sculk sensors right above them in the attic or roof space.
  • Mob Spawning Warning: Because these lights stay off when nobody is around, the area will be dark most of the time. In survival worlds with hostile mobs enabled, make sure to spawn-proof your floors and paths using slabs, carpets, buttons, or hidden ambient lighting so monsters don't spawn in the dark.
  • Cross-Edition Compatibility: This simple mechanic works identically in both Minecraft Java Edition and Bedrock Edition.

Frequently asked questions

Why do you need to put water inside the sculk sensor?
Waterlogging the sculk sensor completely silences its loud clicking and humming sound effects while still letting it detect movement and power the redstone lamp.
Will mobs spawn when the motion lights turn off?
Yes, hostile mobs can spawn when you walk away and the lamps turn off. If you play on Easy, Normal, or Hard difficulty, use slabs, carpets, or extra hidden lighting to keep your base spawn-proof.
Do you need Silk Touch to get a sculk sensor in survival?
Yes, sculk sensors found in the Deep Dark biome must be mined with a tool enchanted with Silk Touch (a hoe is the fastest tool), otherwise they only drop experience.

Components used

More automatic lights