Short Pulse Monostable Circuit

A monostable circuit (or pulse limiter) takes a long input signal, such as a standard button press, and converts it into a much shorter output pulse. This classic torch-and-repeater design is completely silent and lets you easily fine-tune your pulse length for mechanisms like rapid trapdoors or Pez dispenser minecart systems.

Pulse CircuitsBeginnerJava Edition
Short Pulse Monostable Circuit video tutorial

Video: The Monostable Circuit For Very Short Pulses by Minecraftaddict

How to build it

  1. Place the Input Block and Torch

    Place a solid block on the ground and attach a button to one side for your input. On the opposite side of that same block, attach a redstone torch.

  2. Add the Delay Repeater

    Place a redstone repeater leading away from the input block (or branching off the input redstone dust line) so that it gets powered when the button is pressed. Right-click the repeater once to set it to at least a 2-tick delay.

  3. Set Up the Output Block and Second Torch

    Place a second solid block directly in front of the repeater. Attach your second redstone torch to the side of this output block so the repeater powers the block and turns this torch off.

  4. Connect the Torches Together

    Run a short line of redstone dust from the first redstone torch to the output block, or wire both torches into a shared output line so the first torch keeps the output off until the button is pressed.

  5. Fine-Tune the Pulse Length

    Press the button to test the short output pulse. If you need a slightly longer pulse that is still shorter than a full button press, adjust the repeater to 3 or 4 ticks, or add a second repeater in series.

How it works

This circuit functions similarly to half of an RS NOR latch, using the timing difference between two parallel paths to cut off a signal early:

  • Resting State: Before you press the button, the first redstone torch is ON, while the redstone repeater path is unpowered.
  • Activation: When the button is pressed, the input block is powered simultaneously down two paths. The first torch turns OFF after 1 redstone tick, allowing the output to briefly change state.
  • Pulse Cutoff: Meanwhile, the signal travels through the repeater (set to at least 2 ticks). Once the delayed signal exits the repeater, it powers the far torch/output line and cuts off the pulse long before the button naturally pops back out.

Tips & variations

  • Minimum Repeater Delay: Always set the repeater to at least the second position (2 ticks). On a 1-tick setting, the repeater and the first redstone torch switch at the exact same speed, preventing the short pulse from forming.
  • Extending the Pulse: To get a pulse between 4 ticks and a full button press, simply place a second repeater in line with the first and adjust its delay ticks to fine-tune the timing.
  • Great for Minecart Dispensers: Because it has no pistons, this circuit is completely silent and ideal for early-game Pez dispensers or rapid trapdoor triggers.

Frequently asked questions

Why doesn't the circuit output a pulse on a 1-tick repeater setting?
A redstone torch naturally takes 1 redstone tick to invert. If the repeater is also set to 1 tick, both paths update at the exact same time and cancel each other out. Setting the repeater to at least 2 ticks creates the timing gap needed for a pulse.
How do I make the pulse slightly longer but still shorter than a button?
Click the repeater to set it to 3 or 4 ticks. If you need a slightly longer pulse than one repeater allows, place a second repeater right behind it and adjust its ticks.
What can I power with a short pulse monostable circuit?
It is commonly used to flick trapdoors open and shut rapidly, trigger minecart Pez dispensers without letting a second cart slip through, or activate any mechanism that needs a quick trigger rather than a long button signal.

Components used

More pulse limiter