
Video: Minecraft Redstone Tutorial: Pulse Limiter by BrenyBeast
How to build it
- Place the Base Blocks and Repeater
Place two solid building blocks on the ground with a one-block gap between them. Place a redstone repeater in the gap, facing away from your chosen input block toward the second block.
- Add the Input and First Torch
Attach a button to the input block. On either the left or right side of this same input block, attach a redstone torch.
- Route the Redstone Dust
Place redstone dust on the ground next to the redstone torch, leading alongside the repeater and directly up onto the top of the second solid block.
- Place the Output Torch
Attach a second redstone torch to the front or opposite side of the second block (away from the dust trail so it doesn't loop back). The dust on top of that block keeps this output torch turned off by default.
- Adjust the Repeater Delay
Right-click the redstone repeater to set it to the 3rd notch (3 ticks). Connect your output line or a door to the second torch and press the button to test the quick pulse.
How it works
This circuit works by racing two signals of different speeds against each other to create a brief window where the output torch can turn on:
- Resting State: The first redstone torch is ON, powering the redstone dust trail leading onto the top of the second block. Because the second block is powered by the dust, the output redstone torch attached to it is held OFF.
- Activation: When you press the button, the input block becomes powered. This immediately does two things: it turns OFF the first redstone torch, and it starts sending power into the redstone repeater.
- The Pulse Window: As soon as the first torch turns off, the dust on top of the second block depowers, allowing the output torch to turn ON. However, a split second later, the delayed signal from the repeater finishes traveling into the second block, strongly powering it and forcing the output torch back OFF.
- Reset: When the button eventually pops out, the repeater turns off before the first torch turns back on, keeping the second block powered throughout the reset so the output torch does not flicker a second time.
Tips & variations
- Directional Quirks (North/South Rule): In older Java versions, redstone update order can depend on the compass direction you build the circuit. Depending on which way your circuit faces, the repeater may work reliably on the 2nd notch (2 ticks) for an even faster pulse, while other orientations require the 3rd notch (3 ticks) to actually trigger your output mechanism.
- Silent Operation: Because this design relies on torch inversion rather than a sticky piston pushing a block, it makes zero piston noise.
- Output Placement: You can place the output torch on either free side of the second block—just make sure it is not placed directly above or adjacent to the input redstone dust line.





