Bedrock Pulse Shortener

A redstone pulse shortener—also known as a rising-edge monostable circuit—converts a long redstone signal (like a button press or lever flip) into a crisp 1-tick output pulse. This simple, silent design requires no pistons or quartz, making it ideal for survival worlds when you need precise timing, such as letting a locked hopper transfer only a single item.

Pulse CircuitsBeginnerBedrock Edition
Bedrock Pulse Shortener video tutorial

Video: shorten a redstone pulse (monostable circuit) PS4 legacy and bedrock by Darth_ Dub_

How to build it

  1. Place the Base Blocks

    Place two solid building blocks on the ground with a 1-block gap between them.

  2. Install the Repeater

    Place a redstone repeater in the gap between the two blocks, facing from the first (input) block toward the second block. Adjust the repeater to a 3-tick delay (click it twice).

  3. Attach the Redstone Torches

    Place one redstone torch on the side of the first block (orthogonal to the repeater) and the second redstone torch on the front or side of the second block. The second torch will immediately turn off because the repeater is not yet powered, or wait until the dust is connected.

  4. Connect the Redstone Dust

    Run 3 pieces of redstone dust along the ground to connect the side of the first block, its redstone torch, and the block holding the second redstone torch.

  5. Add Your Input and Output

    Attach a button, lever, or input redstone line directly to the first block. Your 1-tick shortened pulse will come out of the second redstone torch.

How it works

This circuit works as a classic NOR-gate pulse limiter by racing a fast signal against a delayed signal:

  • Resting State: The first redstone torch is ON. It powers the redstone dust line, which powers the second block and keeps the output redstone torch turned OFF.
  • Activation: When you power the first block with a button or lever, two things happen simultaneously: the first torch turns OFF (after 1 redstone tick), and the 3-tick repeater starts powering up.
  • The 1-Tick Window: Because the first torch turns off before the 3-tick repeater finishes its delay, the second block briefly loses all power. This allows the output redstone torch to flash ON for a single tick before the repeater signal arrives to shut it back OFF.
  • Reset: When your input turns off, the repeater stays powered slightly longer than the first torch takes to turn back on, preventing any accidental second pulse.

Tips & variations

  • Adjusting Pulse Length: The repeater is set to 3 ticks to create a 1-tick pulse on Bedrock Edition. Increasing the repeater to 4 ticks will lengthen the output pulse slightly.
  • Hopper Control: Use this circuit to briefly unlock a powered hopper so that it drops exactly one item into a container or dropper.
  • Completely Silent: Because it only uses torches and a repeater instead of sticky pistons, this monostable circuit makes zero noise.
  • Torch Placement: You can mount the final output torch on either the front or the side of the second block depending on where you want your output wire to go.

Frequently asked questions

Why does the repeater need to be on 3 ticks?
In Minecraft Bedrock Edition, a 3-tick delay on the repeater creates the exact timing difference needed against the first redstone torch turning off to let the output torch flash for 1 tick.
Does this pulse shortener work with a lever or continuous signal?
Yes. Even if you feed a constant ON signal into the input block, the output torch will only emit a single 1-tick pulse and then remain off until the input is turned off and back on again.
What is a practical use for a 1-tick pulse in Bedrock?
It is great for precise hopper item dispensing (letting only one item pass through) or triggering circuits that would break if held on for the full duration of a stone or wooden button press.

Components used

More pulse limiter