
Video: Small Self Resetting Counter: Silent & Fast | Minecraft by Maizuma Games
How to build it
- Place the Counting Droppers
Place two droppers facing directly into each other. Attach a button to the first dropper (or an adjacent solid block) to serve as your pulse input, and fill this first dropper with the exact number of stackable items you want to count.
- Set Up the Empty Detector
Place a redstone comparator reading from the first dropper running into a solid block. Attach a redstone torch to that block; this torch stays off while items remain in the dropper and turns on once the count finishes to serve as your output.
- Build the Dropper RS NOR Latch
Next to the output torch, place a second pair of droppers facing into each other to act as an RS NOR latch. Put a single non-stackable item inside the dropper that gets triggered when the output torch turns on.
- Wire the Subtraction Reset Clock
Place a comparator reading from the second latch dropper and right-click it to set it to subtraction mode. Loop redstone dust and a repeater back into the side of this comparator to create a fast 1-tick subtraction clock that powers the second counting dropper.
- Add the Reset Stop Sensor
Place a third comparator reading from the second counting dropper (which holds the counted items). Wire a redstone torch and pulse line from this comparator back to the second latch dropper so that when all items finish returning to the first dropper, the latch flips back and stops the clock.
- Add Manual Reset and Indicator
Optionally, place a button on the first latch dropper to manually trigger an early reset at any time, and place a redstone lamp near the output to indicate while the system is actively resetting.
How it works
This circuit relies on two paired dropper sets: one for counting and one acting as a memory latch to control the reset cycle.
- Counting Phase: Each input pulse weakly powers the first dropper, pushing one item into the second counting dropper. While items remain in the first dropper, its comparator keeps the output redstone torch turned off.
- Triggering the Output & Latch: When the final item leaves the first dropper, the comparator turns off and the output torch turns on. This powers the first latch dropper, pushing a single non-stackable item into the second latch dropper.
- Fast Reset Clock: A non-stackable item outputs a higher signal strength through the comparator, activating a 1-tick comparator subtraction clock. This clock rapidly fires the second counting dropper, sending all counted items back into the starting dropper.
- Completion: A third comparator monitors the second counting dropper. As soon as it empties completely, the comparator turns off, sending a pulse to the latch to return the non-stackable item and halt the reset clock.
Tips & variations
- Weak Power Input Only: Always power the input dropper weakly (such as placing a button on it or powering an adjacent solid block). Do not run a repeater, comparator, or redstone dust directly into the dropper, as strong power will also activate the facing dropper and cause items to bounce back and forth.
- Counting Capacity: A dropper has 9 slots, meaning you can load up to 576 stackable items (9 stacks of 64) to count up to 576 pulses in a single unit.
- Sound Profile: The circuit is completely silent while counting and resetting, only producing a single dropper click at the very end when the final pulse fires on an empty dropper.
- Applications: Use this in automated XP farms to count a specific number of mobs before dispensing a potion, or in combination locks that require a specific number of button presses.





