
Video: Minecraft: The Redstone Counting System [Day 13!] by Mumbo Jumbo
How to build it
- Build the Dropper-Hopper Pulse Limiter
Place a dropper facing upwards and crouch-place a hopper on top of it pointing straight down into the dropper. Put a single item inside the dropper and attach a button to the side of it.
- Wire the Monostable Output
Place a solid block next to the dropper with a redstone comparator on top reading from the dropper into another solid block. Place redstone dust on top of that block and run it into a repeater facing toward where your hopper chain will go.
- Create the Hopper Loop
Build a line of five hoppers pointing into one another for the front display row. At the end of the row, continue placing hoppers in a loop around the back so the final hopper feeds right back into the very first hopper of the front row.
- Lock the Front Hopper Row
Crouch-place redstone dust directly on top of the five front-row hoppers, connecting them to the output of your repeater. Notice that the return hoppers along the back are left without redstone dust on top.
- Add the Comparator Readers
Place a row of solid blocks along the front of the five main hoppers. Put a redstone comparator on top of each block facing away from the hoppers to read their inventories.
- Install the Redstone Lamps and Item
Place a solid block in front of each comparator and put a redstone lamp on top of each block. Finally, drop a single item into the first front-row hopper to initialize the counter.
How it works
The core of this counter is an inverted dropper-hopper monostable circuit paired with a partially locked hopper ring:
- Resting State: The dropper holds one item. A comparator reads this item and powers a repeater, which sends a full signal across the redstone dust sitting on top of the five front hoppers. Because these hoppers are powered, they are locked and cannot push the counting item forward.
- Stepping Forward: When you press the button, the dropper shoots its item up into the hopper above it. For a brief moment the dropper is empty, so its comparator and the locking redstone line turn off.
- Exact Pulse Timing: The hopper above the dropper immediately returns the item back down into the dropper, turning the locking redstone line back on. That short off-pulse is just long enough for the item in the front hopper chain to advance by exactly one hopper before the row locks again.
- Automatic Reset: Each front hopper has a comparator lighting up a
Redstone Lampwhenever the item is inside it. When you press the button while the item is in the final front hopper, it moves into the unpowered back row of hoppers, travels freely around the loop, and stops again as soon as it enters the first locked hopper.
Tips & variations
- Easy Expansion: You can make the counter as long as you want by adding more hoppers, comparators, and lamps to the front row. If your front row exceeds 15 blocks, you will need a repeater to extend the locking signal, which adds a slight delay to the back end.
- One-Item Rule: Make sure you only put a single item inside the dropper and a single item inside the hopper ring. Multiple items in the dropper will keep the comparator powered continuously and break the pulse timing.
- Crouch Placement: Hold sneak (Shift) while placing hoppers into each other and while placing redstone dust on top of hoppers so you do not open their inventory screens.





