Tiny Toggleable Comparator Clock

A comparator subtraction clock is one of the smallest and fastest toggleable pulse generators you can build in Minecraft. By looping a comparator's output right back into its side input, it rapidly flashes on and off to power dispensers, droppers, or note blocks. Because it can be toggled with a simple lever or by clicking the comparator itself, it is ideal for survival automation when space is tight.

ClocksBeginnerJava & Bedrock
Tiny Toggleable Comparator Clock video tutorial

Video: Tiny Toggle-able Clock (Comparator) - Minecraft Xbox/Playstation - [Tutorial] by OverlookeDEnT

How to build it

  1. Place the Redstone Comparator

    Place one Redstone Comparator on the ground facing toward where you want your output line to go.

  2. Loop Redstone Dust to the Side

    Place a piece of Redstone Dust directly in front of the comparator, then wrap two more pieces around to connect into either the left or right side of the comparator.

  3. Attach the Lever Input

    Place a Lever directly behind the comparator's rear input (or on a solid block feeding into the back of the comparator).

  4. Enable Subtract Mode and Toggle

    Interact with the comparator to turn on its front torch (subtract mode), then flip the lever on to start the rapid pulsing clock.

  5. Extend the Output Line

    Run at least two additional pieces of Redstone Dust forward from the front of the clock so the signal strength decays enough to visibly toggle your target blocks on and off.

How it works

This circuit relies on the subtract mode mechanic of the Redstone Comparator:

  • Initial Power: When the lever is flipped on, it feeds a full signal strength of 15 into the rear input of the comparator.
  • Feedback Loop: With the comparator in subtract mode (front torch lit), it outputs signal strength 15 to the dust in front of it. That signal travels around the 3-dust loop into the comparator's side input, losing a bit of strength along the way (arriving at strength 13).
  • Subtraction Cycle: The comparator subtracts the side input (13) from the rear input (15), dropping its output to 2. Because a signal strength of 2 is too weak to reach the side input around the loop, the side input drops to 0 on the next tick, causing the output to jump back to 15 and repeat the cycle endlessly.
  • Two Ways to Toggle: Turning off the lever leaves the output completely OFF. Leaving the lever on and switching the comparator back to compare mode (front torch off) pauses the clock while keeping the output line constantly ON.

Tips & variations

  • Distance Quirk (Signal Strength): Because the comparator's output toggles between 15 and 2 (rather than 15 and 0), dust right next to the clock never fully turns off. You must place your output device, repeater, or redstone torch at least 2 to 3 blocks away from the front of the comparator so the weak pulse dies out completely between cycles.
  • Inverting the Resting State: If you need the circuit to rest in the opposite state when turned off, run the output dust at least two blocks out into a solid block with a Redstone Torch attached, or add a Redstone Repeater along the extended line to adjust the pulse length.
  • Common Mistake: Putting a Redstone Torch or Repeater directly adjacent to the 3-dust loop will prevent it from pulsing because the signal strength at the loop never drops to zero.

Frequently asked questions

Why isn't my redstone torch or repeater flashing when connected to the clock?
The dust right next to the comparator only drops to signal strength 2 instead of 0. Extend your redstone dust line at least 2 or 3 blocks away from the front of the comparator before placing your torch, repeater, or mechanism.
How do I stop the clock with the output staying ON instead of OFF?
Leave the lever turned ON and right-click (or interact with) the comparator to turn off its front subtract-mode torch. To stop it in the OFF state instead, simply flip the lever off.
Does this comparator clock work on both Bedrock and Java Edition?
Yes. Although originally demonstrated on console and 1.6.4, comparator subtraction clocks use fundamental signal-strength mechanics that work in both Java and Bedrock Editions.

Components used

More comparator clock