Comparator Decay Clock

A comparator decay clock, often used as a pulse extender, takes a brief input signal like a button press and stretches it into a much longer output pulse. Even after the button pops back out, the circuit keeps your contraption powered while the signal slowly fades away. It is one of the easiest and most compact ways to hold doors open or keep farms running for a few extra seconds.

ClocksBeginnerJava Edition
Comparator Decay Clock video tutorial

Video: How to Build a Comparator Decay Clock in Minecraft! by Mr. Technician

How to build it

  1. Set Up the Input Pulse

    Place your input source, such as a button, and run a line of redstone dust out from it. While a button is used for testing, any short redstone pulse will work as the input.

  2. Place the First Comparator

    Place a redstone comparator facing away from the input redstone dust so that the pulse feeds directly into the back of the comparator.

  3. Complete the Comparator Loop

    Right next to the first comparator, place a second redstone comparator facing the exact opposite direction. Connect the open ends of both comparators using redstone dust so they form a closed loop.

  4. Connect the Output Repeater

    Run your output from the redstone dust on the opposite side of the comparators from the input. Place a redstone repeater facing outward from that dust to restore the decaying signal to full strength for your contraption.

How it works

This circuit works by slowly draining signal strength around a loop:

  • Charging the Loop: Pressing the button sends a full-strength redstone signal into the first Redstone Comparator.
  • Signal Decay: Because the two comparators face opposite directions and are linked by Redstone Dust at both ends, the signal cycles continuously between them. Each time the signal travels from the output of one comparator through the adjacent dust into the back of the other comparator, its signal strength drops by 1.
  • Full Output Power: The circuit stays active until the signal strength decays all the way down to zero. Placing a Redstone Repeater at the output boosts any remaining signal (strength 1 to 15) back up to a steady full power of 15 until the clock completely runs out.

Tips & variations

  • Extending the Delay: You can easily make the output last longer by expanding the loop with additional pairs of comparators (such as 4, 6, 8, or 10 comparators total). The more comparators the signal has to travel through before decaying, the longer the circuit stays on.
  • Flexible Wiring: The input and output lines can connect from any direction around the end dust, as long as the output is taken from the opposite side of the comparator pair from the input.
  • Input Caution: Make sure your input is a brief pulse (like a button or observer) rather than a constant signal (like a lever), as the decay only begins once the input turns off.

Frequently asked questions

What does a comparator decay clock do?
It acts as a pulse extender, taking a short redstone pulse (like a button press) and keeping the output turned on for a longer period before shutting off.
How do I make the signal stay on longer?
Add more comparators to the loop in pairs facing opposite directions (for example, 4, 6, or 8 comparators). Each additional pair increases the time it takes for the signal to decay to zero.
Does it matter which side the output comes from?
You can pull the output from any direction, provided it is connected to the redstone dust on the opposite end of the comparators from the input pulse.

Components used

More comparator clock