Redstone Comparator Oscillator Clock

A redstone comparator clock is a simple, silent oscillating circuit that rapidly turns a redstone signal on and off. By looping a comparator's output back into its side input while in subtraction mode, you can create a fast pulse ideal for powering dispensers, droppers, or flashing redstone lamps. You can also easily adjust the speed of the clock by adding and tuning redstone repeaters inside the feedback loop.

ClocksBeginnerJava & Bedrock
Redstone Comparator Oscillator Clock video tutorial

Video: Minecraft: Redstone Comparator Clock by Distorted Order

How to build it

  1. Place the Redstone Comparator

    Set a redstone comparator on the ground. Note that the end with the two torches is the main rear input, and the end with the single small torch is the front output.

  2. Add a Power Source and Output

    Place a redstone torch directly behind the two-post input side to supply power. For testing, place a redstone lamp at the front output of the comparator; it should light up immediately.

  3. Build the Feedback Loop

    Run a line of redstone dust from the front output of the comparator around to one of its side inputs. Place a redstone repeater inside this loop to help control the signal delay.

  4. Enable Subtraction Mode

    Right-click (or use the secondary action button) on the comparator to turn on its front torch. This switches it to subtraction mode and starts the rapid clock oscillation.

  5. Adjust the Repeater Delay

    Click the redstone repeater in the loop to increase its tick delay. Slowing the pulse down allows slower components, like the redstone lamp, enough time to visibly flash on and off.

  6. Extend the Clock (Optional)

    If you need an even slower pulse, replace another segment of redstone dust in the feedback loop with a second redstone repeater and adjust its delay settings as needed.

How it works

This circuit works by using a feedback loop combined with the comparator's subtraction mode:

  • Initial Power: The redstone torch supplies a constant signal strength of 15 into the rear input of the comparator, which immediately exits the front output.
  • Feedback & Subtraction: The output signal travels through the redstone dust and repeater loop into the side of the comparator. When the comparator is toggled into subtraction mode (front torch lit), it subtracts the side input strength from the rear input strength.
  • Oscillation: Because the repeater outputs a full-strength signal of 15 into the side, the comparator calculates 15 - 15 = 0 and turns its output off. Once the output turns off, the side input loses power after a short delay, returning the calculation to 15 - 0 = 15. This cycle repeats endlessly, creating a clock.

Tips & variations

  • Redstone Lamp Delay: Redstone lamps take 2 redstone ticks to turn off. If your comparator clock is running at its fastest 1-tick speed, the lamp will stay permanently lit even though the redstone dust is flashing. Always add a repeater and increase its delay if you are powering lamps.
  • Toggleable Clock: You can replace the rear redstone torch with a lever so you can easily turn the clock on and off whenever you want.
  • Slower Pulses: The more repeaters you chain into the feedback loop, the longer the on and off phases of the clock will last.

Frequently asked questions

Why isn't my comparator clock flashing?
Make sure you have right-clicked the comparator so the single front torch is lit up. It must be in subtraction mode for the feedback loop to turn itself off and on.
Why is the redstone dust flashing, but my redstone lamp stays solidly lit?
The pulse is moving too fast for the redstone lamp to react. Click on the redstone repeater in the loop to add delay and slow the clock down until the lamp begins flashing.
How do I make the clock pulse even slower?
Replace additional pieces of redstone dust in the feedback loop with more redstone repeaters, then adjust their tick delays.

Components used

More comparator clock