
Video: Vertical Redstone Transfer - Really Redstone (HD) by Nikc-Nack & A Moderately Good Time
How to build it
- Method 1: Build a 2x2 Downward Spiral
To send a signal down quickly, build a 2x2 column of blocks stepping downward in a spiral pattern. Place redstone dust on top of each step from the top input down to your output block.
- Extend the Spiral Signal (If Needed)
Because redstone dust only travels 15 blocks, place a solid block with a redstone torch or extend the spiral outward briefly to refresh the signal if your drop is taller than 15 blocks.
- Method 2: Start the 1x2 Downward Torch Ladder
For a more compact 1x2 downward wire, start at the top input block and place a redstone torch on its side. Leave an empty air gap directly below that torch, and place a solid block below the gap with redstone dust on top of it.
- Repeat the 1x2 Downward Pattern
Attach another redstone torch to the side of the block supporting the redstone dust. Alternate this pattern back and forth inside the 1x2 footprint all the way down to your output.
- Method 3: Build a 2x2 Upward Spiral
To send a signal upward with zero wire delay, build the same 2x2 spiral staircase of solid blocks and cover every step with redstone dust. Place your lever at the bottom and your output device at the top.
- Method 4: Build a 1x1 Upward Torch Tower
For the smallest upward footprint, place a solid block on the ground with a redstone torch directly on top of it. Place another solid block directly above that torch, then another torch on top of the new block, repeating as high as you need.
How it works
Each of the four vertical transfer designs trades off between speed, footprint, and height limits:
- 2x2 Dust Spiral (Up or Down): Redstone dust connects diagonally up and down across solid blocks arranged in a 2x2 spiral. The signal travels instantly along the dust, but loses 1 signal strength per block, limiting a single uninterrupted run to 15 blocks.
- 1x2 Downward Torch Ladder: Because redstone torches power the block directly below them through dust, placing a dot of
redstone-dusttwo blocks below a torch picks up its power. That dust powers the block it sits on, inverting the attached side torch and passing the signal downward step by step. - 1x1 Upward Torch Tower: A redstone torch strongly powers the solid block directly above it. That powered block turns off the torch sitting on top of it, creating an alternating vertical chain of ON and OFF torches that can reach any height.
Tips & variations
- Watch the Delay: Every redstone torch in the 1x1 upward tower and 1x2 downward ladder adds 1 redstone tick (0.1 seconds) of delay. Use the 2x2 dust spiral whenever speed matters more than space.
- Signal Inversion: If your torch tower has an odd number of torches, the output at the end will be inverted compared to your lever input. Add or remove one torch step to flip the final state.
- 15-Block Dust Limit: When using either 2x2 spiral method, always count your dust pieces. After 15 dust, the signal dies out unless you refresh it.





