
Video: How to Send Redstone Signals Vertically | Minecraft Redstone Tutorial | Zaper by Zaper
How to build it
- Build the Water Tube (Upward Signal)
To send a signal from bottom to top, build a vertical 1x1 tube enclosed on four sides using solid blocks or glass to reaches your desired height. Leave a 1-block opening at the bottom base of the tube.
- Fill with Water Source Blocks
Fill the entire vertical tube with water source blocks from the bottom all the way to the top.
- Place the Soul Sand Piston
At the bottom of the tube, place a sticky piston facing horizontally toward the space directly beneath the water column. Attach a block of Soul Sand to the face of the sticky piston and connect your input lever to the piston.
- Add the Top Observer
Place an observer at the very top of the water column with its face looking down into the top water source block. Place your output block (such as a redstone lamp) on the back of the observer.
- Build a 3-Wide Wall Column (Downward Signal)
To send a signal from top to bottom, build a flat, 3-block-wide vertical sheet of walls (such as stone or cobblestone walls) extending from your upper input down to your lower destination. Because it is 3 blocks wide, the middle column of walls will automatically become smooth and flat.
- Place the Top Trigger Piston
At the very top of the wall structure, position a sticky piston holding a solid block so that when extended, the block pushes directly against the side of the middle wall column.
- Place the Bottom Observer
At the very bottom of the wall structure, place an observer facing the bottom-most middle wall block. Connect your output lamp or circuit to the back of this observer.
How it works
Both circuits rely on block states propagating vertically and being read by an Observer:
- Upward Bubble Column: When the lower sticky piston pushes the Soul Sand under the water source blocks, it converts the normal water into a rising bubble column. This state change travels up the water tube to the top block, where the observer detects the block update and emits a redstone pulse. Pulling the Soul Sand back turns the column back into regular water, sending a second update.
- Downward Wall Column: When walls are placed in a 3-wide flat sheet, the center column connects only to the left and right, maintaining a smooth, flat profile. When the top sticky piston pushes a solid block next to the top-center wall, that wall connects to the block and gains a thick center post. Because wall post connections depend on the walls above them, every single center wall block all the way down to the bottom instantly updates to a post state, which the bottom observer immediately detects.
Tips & variations
- Convert Pulses to Toggles: Because observers only output a quick pulse whenever the bubble column or wall changes state, attach a T Flip-Flop (like a Copper Bulb) to the observer output if you want a continuous on/off signal matching your lever.
- Water Source Requirement: Every single water block in the upward tube must be a full water source block, not flowing water, or the bubble column will stop partway up. You can place kelp from bottom to top in flowing water and break it to quickly convert the tube into source blocks.
- Directional Limits: Remember that bubble columns only propagate upward from the floor, and wall pillar updates only propagate downward from the top.





