One-Shot Arrow Railgun

An arrow railgun uses compressed TNT explosions to accelerate arrows to extreme speeds, allowing them to bypass full Protection IV Netherite armor and kill players in a single hit. Because Minecraft calculates arrow damage by multiplying base damage by velocity, detonating 48 TNT behind suspended arrows generates more than enough raw damage to one-shot any target. This cannon is ideal for base defense, PvP traps, or testing high-velocity game mechanics.

TNT & CannonsIntermediateJava Edition
One-Shot Arrow Railgun video tutorial

Video: How to build ONE SHOT ARROW RAILGUNS in Minecraft by ProfessorTNT

How to build it

  1. Build the Soul Sand Base

    Place a 1x6 line of soul sand on the ground. Next to both long sides of the soul sand, place a line of temporary solid blocks.

  2. Stack the 48 TNT Dispensers

    On top of the temporary blocks on both sides, build walls of dispensers facing inward toward the soul sand channel. Make each wall 6 blocks long and 4 blocks high for a total of 48 dispensers.

  3. Seal the Chamber Ends

    Close off the back of the channel with solid blocks. At the front, build a 1-block compression pocket for the TNT to collect in, and place a sideways chain at the front opening to stop both the water and TNT while leaving room for the blast.

  4. Create the Bubble Stream

    Place a water source at the top-back of the chamber and use temporary blocks right underneath it so the water flows all the way to the front. Break the temporary blocks and fill every block space underneath the top flowing layer with water source blocks (or use kelp) so the soul sand creates bubble columns pushing upward into the front-flowing stream, then cap the roof with glass or solid blocks.

  5. Build the Arrow Holder

    At the front of the cannon, place a plus-shape of soul sand to create a 1x1 water column directly in front of the TNT pocket. Surround the water column spot with trapdoors or pressure plates to contain the water.

  6. Install the Arrow Dispenser

    Place a 49th dispenser at the top of the front section facing into the arrow chamber. Attach a trapdoor anchored to the top of the block in front of it, and fill the 1x1 arrow column with water so it forms a bubble column.

  7. Build the Checkerboard Wiring Frame

    Break the temporary blocks beneath the TNT dispensers. Starting four blocks out from the backmost soul sand, place a checkerboard pattern of solid blocks climbing up alongside the outer wall of dispensers.

  8. Wire the TNT Dispensers

    Extend transparent blocks (such as glass or glowstone) outward from the solid checkerboard blocks and run redstone dust across all of them so the dust points directly into every dispenser. Mirror this exact wiring structure on the opposite side of the cannon and connect both sides to a single button at the back.

  9. Build the Rapid Arrow Clock

    At the top arrow dispenser, attach a lever and flick it on to keep the clock off while building. Place redstone dust on top of the dispenser, attach two redstone torches to the sides of the block, and place solid blocks on top of those torches to form a fast torch burnout clock.

  10. Load and Fire the Railgun

    Fill the 48 chamber dispensers with TNT and the top dispenser with arrows. Flick the lever to run the arrow clock until a dense batch of arrows is bobbing in the front bubble column, turn the lever off, and press the back button to fire.

How it works

The railgun relies on Minecraft's projectile velocity damage formula, where an arrow's final damage equals its base damage (2) multiplied by its velocity in blocks per tick.

  • Damage Threshold: To deal 20 hearts of damage through full Protection IV Netherite armor and armor toughness, an arrow needs roughly 72 raw damage (or about 67 for Diamond armor), which requires a speed of at least 36 blocks per tick.
  • TNT Acceleration: Each exploding TNT adjacent to an arrow adds roughly 1 block per tick of velocity. Because arrows lose 1% of their velocity every tick they travel, 36 TNT would only lethal-range out to 36 blocks. Using 48 TNT (two 6x4 walls) gives enough speed buffer for long range and slight alignment variances.
  • Bubble Chamber Compression: The soul sand bubble columns lift all 48 primed TNT off the ground so they experience zero floor friction, allowing the top water stream to push every TNT cleanly against the front sideways chain before detonation.
  • Arrow Spread & Bobbing: As the torch clock fires arrows into the top trapdoor, the trapdoor rapidly opens and closes. Each arrow drops into the front soul sand bubble column at a slightly different time, giving it an independent vertical bobbing cycle and producing a buckshot-style spread when the TNT detonates.

Tips & variations

  • Don't Use Instant Damage Arrows: Tipped arrows of Harming are useless here—the effect only forces arrow damage to 12 if the base physical hit deals less than 12 damage, whereas these arrows already deal over 72 physical damage.
  • Adjusting Horizontal & Vertical Spread: Moving the arrow dispenser further back from the trapdoor increases the horizontal bloom. If you want clustered waves of arrows at distinct heights rather than uniform buckshot, leave the trapdoor closed while firing batches of arrows and manually open it periodically.
  • Transparent Block Wiring: Make sure to use transparent blocks like glass or glowstone for the outer redstone ladders so the signal travels upward diagonally without cutting its own wire.

Frequently asked questions

Can this arrow railgun really one-shot full Protection IV Netherite armor?
Yes. Full Protection IV Netherite requires about 72 raw damage to deal 20 hearts in one hit, and the 48 TNT charges accelerate the arrows well past the 36 blocks-per-tick speed needed to reach 72 damage.
Why does the cannon use 48 TNT when only 36 TNT is needed for 72 damage?
Arrows lose 1% of their speed every game tick. Using 48 TNT instead of the bare minimum 36 ensures the arrows stay above the one-shot velocity threshold over a longer distance and compensates for slight angle spreads.
Why use soul sand in the water chamber instead of normal flowing water?
Soul sand bubble columns keep the primed TNT floating so it never touches the floor. This removes ground friction and lets the top flowing water compress all 48 TNT into the front chain pocket much faster.
Do Instant Damage II arrows make the railgun stronger?
No. In Minecraft, the Harming effect on an arrow only sets damage to 12 if the arrow's kinetic damage is under 12. Since railgun arrows deal over 72 damage from speed alone, regular arrows work identically.

Components used

More tnt cannon