Simple SR Latch

An SR latch (Set-Reset latch) is a fundamental redstone memory cell that remembers whether it was last turned on or off. It allows you to use one momentary input, like a button, to permanently power a mechanism, and a second separate input to shut it back off. This circuit is essential for control panels, automated farm toggles, and security locks.

Memory CircuitsBeginnerJava Edition
Simple SR Latch video tutorial

Video: Need To Know: SR Latches by Properinglish19

How to build it

  1. Place the Base Blocks

    For the classic torch-based latch (RS NOR latch), place two solid building blocks on the ground with a small gap between them.

  2. Attach Redstone Torches

    Place a redstone torch on the side of each block so that the torches face toward each other across the gap.

  3. Cross-Wire the Torches

    Run redstone dust from the output of the first torch into the block holding the second torch, and run a second line of dust from the second torch back into the first block. One torch will immediately turn off while the other stays on.

  4. Add Set and Reset Inputs

    Attach one button (Set) to a line powering the first block, and a second button (Reset) to the opposite block, then take your main output line from one of the two sides.

  5. Alternative: Build a Signal Loop

    For the second design shown, create a small closed loop of redstone dust and a repeater that feeds power continuously back into itself once triggered by the Set input.

  6. Add a Loop-Breaker Reset

    Set up your Reset input to physically break or cut off a block in the feedback loop so the circulating signal dies out and resets the cell to off.

How it works

An SR latch stores a single bit of memory using two inputs: Set (S) and Reset (R).

  • Torch Design (RS NOR Latch): Two redstone torches (NOR gates) feed into each other's supporting blocks. Only one torch can be on at a time, because the active torch powers the opposite block and forces the other torch to stay off. Pressing the Set button manually powers the active torch's block, turning that torch off. This releases the second torch so it can turn on, which activates your output and locks the first torch in the off state. Pressing Reset reverses the process.
  • Signal Loop Design: Pressing Set injects a pulse into a closed redstone loop. Because the loop powers itself continuously, the output stays on indefinitely after the button pops back out. Pressing Reset interrupts the line so the signal cannot complete the loop, draining all power from the cell.

Tips & variations

  • Terminology Note: An RS NOR latch is a specific type of SR latch built using two NOR gates (redstone torches). Not every SR latch uses NOR gates, as shown by the signal-loop variant.
  • Upgrading the Loop Design: The loop-style SR latch is heavily recommended for advanced circuits because it can easily be modified into a D flip-flop (sometimes called a "Basil flop").
  • Silent Operation: Use the two-torch RS NOR design if you want a completely silent memory circuit with zero piston noise.

Frequently asked questions

What is the difference between an SR latch and an RS NOR latch?
An SR latch is any memory circuit with Set and Reset inputs, while an RS NOR latch is a specific SR latch design built from two cross-connected NOR gates (redstone torches).
Why would I use an SR latch instead of a lever?
An SR latch lets you turn a circuit on from one location and turn it off from a completely different location using buttons, pressure plates, or detector rails.
What happens if neither button is pressed?
The circuit holds its last state indefinitely, keeping your output either permanently on or permanently off until the opposite input is triggered.

Components used

More rs latch