
Video: Minecraft: Smallest Silent RS-NOR latch [Day 6] by Mumbo Jumbo
How to build it
- Place the Input Blocks and Buttons
Place two solid building blocks next to each other (or adjacent to where your droppers will sit) and attach a button to each block. These two buttons act as your Set and Reset inputs.
- Position the Two Droppers
Place two droppers directly next to each other so that their mouths are facing directly into one another. Make sure each dropper is adjacent to one of your button blocks so the buttons can power them.
- Add a Single Item
Open the inventory of either one of the droppers and place a single random item inside. Leave the second dropper completely empty.
- Attach Comparator Outputs
Place a redstone comparator facing outward from each of the two droppers. The comparator reading the dropper with the item inside will turn on, giving you your active output.
How it works
This memory circuit works by tracking the location of a single item between two containers:
- Holding State: Because only one dropper contains an item, only the Redstone Comparator reading that specific dropper outputs a signal. The other comparator remains off.
- Switching State: Pressing the button next to the full dropper powers it, firing the item directly into the second dropper. The first comparator turns off and the second comparator turns on.
- Latching Behavior: Pressing the same button a second time powers an empty dropper, so nothing happens and the output does not change. The output will only switch back when the opposite button is pressed.
Tips & variations
- Keep It Silent: A dropper only makes a clicking sound when triggered while empty. If your input lines only pulse the currently full dropper, the transition is completely silent.
- Signal Strength: A single stackable item inside a dropper produces a comparator signal strength of
1. Place a redstone repeater after the comparator if you need a full strength of15. - Common Mistake: Make sure you use Droppers and not Dispensers—dispensers will try to drop or use the item into the block rather than transferring it into the neighboring container's inventory.
- Avoid Dual Powering: Ensure the button powering one dropper does not accidentally power both droppers at the same time, or the item will bounce right back.





