Basic RS NOR Latch

An RS NOR latch is a foundational redstone memory circuit that remembers which input was activated most recently. Instead of turning off when a button pulse ends, it holds its state until a second reset input is triggered. This makes it ideal for keeping doors open, switching minecart track directions, or building multi-button control systems.

Memory CircuitsBeginnerJava & Bedrock
Basic RS NOR Latch video tutorial

Video: Minecraft Redstone Tutorial: RS NOR Latch (Works on xbox) by BrenyBeast

How to build it

  1. Place the Base Blocks

    Place a line of three solid building blocks on the ground, then break the middle block. You will be left with two blocks separated by a one-block gap.

  2. Attach Redstone Torches

    Place a redstone torch on the inner side of each block so that both torches are facing inward toward each other across the gap, staggered on opposite sides if needed so their wires do not cross.

  3. Connect the First Feedback Wire

    Run redstone dust from the first redstone torch around and directly into the second solid block. You should see the torch on that second block turn off immediately.

  4. Connect the Second Feedback Wire

    Run redstone dust from the second redstone torch around and into the first solid block. This completes the cross-connected memory loop.

  5. Add Your Inputs

    Attach buttons (or run input redstone lines from buttons or pressure plates) into each of the two solid blocks or their corresponding dust lines.

  6. Connect Your Outputs

    Extend a line of redstone dust from either side of the circuit to the device you want to control, such as a pair of doors. Pressing one button will now open one door and close the other, holding that state until the opposite button is pressed.

How it works

The RS NOR latch relies on two cross-coupled NOT gates (the solid blocks with redstone torches attached). At any given time, one torch is ON and the other is OFF:

  • Holding State: The active redstone torch powers the redstone dust leading into the opposite block. Because that block is strongly powered, the redstone torch attached to it is forced OFF.
  • Switching State (Set/Reset): Pressing the button connected to the currently unpowered block sends a pulse into it, turning its torch OFF. Once that torch turns off, it stops powering the opposite block, allowing the other torch to turn ON and lock the circuit into its new state.

Tips & variations

  • Common Mistake: Make sure your redstone dust runs directly into the solid blocks rather than just passing beside them, or the torches will not invert properly.
  • Input Options: While buttons are easiest for testing, you can replace them with pressure plates or detector rails to automatically switch minecart systems when a player or cart passes over.
  • Cross-Edition Compatibility: Because this design only uses basic redstone dust and torch inversion mechanics, it works reliably across all versions of Minecraft, including Java, Bedrock, and legacy console editions.

Frequently asked questions

What does an RS NOR latch do in Minecraft?
It acts as a basic 1-bit memory cell that turns a short pulse (like from a button or pressure plate) into a constant redstone signal until a separate reset button is pressed.
Why are both of my redstone torches turning off or flashing?
If the torches flicker or burn out, the redstone dust is likely feeding back into the same block the torch is attached to. Make sure each torch's wire leads only into the opposite block.
Can I use levers instead of buttons with an RS NOR latch?
No, an RS NOR latch is designed for momentary pulse inputs like buttons, pressure plates, or detector rails. If a lever is left ON, it will lock the circuit and prevent the other side from resetting it.

Components used

More rs latch