Pistonless 1-Wide RS-NOR Latch

An RS-NOR latch is a basic redstone memory circuit with two inputs: one to set the output on, and another to reset it back off. This pistonless, 1-wide vertical design uses only basic redstone torches and dust, making it completely silent, cheap for early survival, and easy to tuck inside tight 1-block-wide walls.

Memory CircuitsBeginnerJava Edition
Pistonless 1-Wide RS-NOR Latch video tutorial

Video: [Redstone] Pistonless 1-wide RS-NOR latch. by Fenno

How to build it

  1. Place the 3 Solid Blocks

    In a single 1-wide vertical plane, place three solid redstone-conducting blocks (like stone or dirt) in an L-like staggered arrangement so one block sits higher and two form the lower base.

  2. Add the Lower Redstone Dust

    Place two pieces of redstone dust on the bottom path leading directly into the lower solid block.

  3. Attach the Redstone Torches

    Place one redstone torch on the lower block so it powers the upper block above it, and attach the second redstone torch to the side of the upper block.

  4. Place the Top Redstone Dust

    Put the third piece of redstone dust on top of the upper block so it receives power from the lower torch and controls the upper torch.

  5. Attach the Input Buttons

    Place one button for your Set input at the bottom and another button for your Reset input at the top.

How it works

This circuit creates a classic two-torch feedback loop compressed into a 1-wide vertical slice:

  • Default State: One redstone torch is on while the other is held off. The active torch powers a solid block and a line of redstone dust, which in turn keeps the second torch inverted (off).
  • Pressing the Bottom Button: Sending a pulse into the bottom dust powers the block holding the lower redstone torch, turning that torch off.
  • State Flip: When the lower torch turns off, it stops powering the block above it. The upper redstone dust turns off, allowing the second redstone torch to turn on and lock the lower dust in the powered state even after the button pulse ends.
  • Pressing the Top Button: Pulsing the upper redstone dust turns off the top torch, which unpowers the bottom line and lets the first torch turn back on, resetting the memory cell.

Tips & variations

  • Use Conducting Blocks Only: The 3 structural blocks must be solid opaque blocks (stone, cobblestone, dirt, wool). Do not use transparent blocks like glass or glowstone for the main 3 blocks, as they cannot carry a redstone current to turn off the attached torches.
  • Prevent Torch Burnout: Do not place a solid opaque block directly above the side redstone torch. A solid block there will create a rapid self-powering loop and cause the redstone torch to burn out. Leave that space as air, or cover it with glass or glowstone if you need to hide the circuit.
  • Taking the Output: Take your output from the active torch or the top/end of the redstone wire. Do not pull an output off the side of the bottom dust feeding into the block, because redirecting that dust away from the block will break the feedback loop.

Frequently asked questions

Why does my redstone torch keep burning out?
You likely placed a solid building block directly above the exposed redstone torch. That creates a fast short-circuit loop. Leave an air gap above the torch or use a transparent block like glass or glowstone.
Why did the latch stop working when I connected my output wire?
If you connect redstone dust to the side of the bottom wire, it redirects the dust so it no longer points into the block holding the torch. Always take your output inline or directly from the torch.
Can I build this RS-NOR latch out of glass or glowstone?
No, the 3 core blocks must be solid redstone-conducting blocks because the torches rely on those blocks being strongly powered to invert their state.

Components used

More rs latch