
Video: Minecraft Easy SILENT Item Elevator (Doesn't leave Any Items) Bedrock Edition Tutorial PE MCPE Xbox by silentwisperer
How to build it
- Place the Bottom Dropper
Clear a 4x1 vertical shaft for your elevator tower plus a small space at the bottom for the starter circuit. Place your bottom dropper facing straight up.
- Add the Comparator Readout
Place a redstone comparator reading out from the bottom dropper into a solid conductive block. Place a piece of redstone dust right next to that block.
- Wire the Base Clock and Return Loop
Run a redstone repeater from the dust into a solid block placed directly against the bottom dropper. Branch out from the circuit with another solid block, a second repeater, and two more pieces of redstone dust to complete the base pulse loop.
- Build the Conductive Block Pillar
Directly on top of the comparator, build a vertical pillar of solid conductive blocks (such as stone or stone bricks) going all the way up to your desired elevator height.
- Build the Alternating Torch and Observer Tower
Starting at the redstone dust at the back of your base circuit, place an observer watching that dust so its output points upward. Place a redstone torch on top of that observer, then another observer watching that torch, alternating observers and torches all the way to the top.
- Add the Horizontal Observer Column
Between the solid block pillar and the alternating torch tower, place a solid vertical column of observers. Make sure their faces point toward the torch/observer tower and their red output dots point straight into the solid block pillar.
- Stack the Dropper Column
Starting on top of your very first dropper, stack upward-facing droppers all the way to the top right against the solid block pillar. Place a chest on top of the final dropper and connect an input hopper to the bottom dropper.
How it works
When an item enters the bottom dropper via the input hopper, the redstone comparator detects it and powers the base clock circuit.
- The base circuit sends a signal through a redstone repeater into the block beside the bottom dropper, firing the item upward into the second dropper while simultaneously cycling the clock.
- The pulsing redstone dust at the rear of the base triggers the bottom observer, which powers a vertical chain of alternating redstone torches and vertical observers.
- As this signal travels upward, the middle column of horizontal observers detects every state change in the torch/observer column and sends a synchronized upward wave of pulses into the solid block pillar.
- Because the solid blocks strongly power the adjacent droppers in exact bottom-to-top sequence, each item is pushed all the way to the top chest in a single smooth pass without empty droppers dry-firing or clicking.
Tips & variations
- Silent Operation: Dropper elevators only click when a dropper is powered while empty, or when the top dropper shoots items into open air. Always place a chest or container directly on top of the final dropper to keep the system 100% silent.
- Use Conductive Blocks: The pillar above the comparator must be made of solid opaque blocks like stone or cobblestone so the observers can power the droppers through them.
- Tower Height: The alternating vertical column can end on either a redstone torch or an observer at the very top without affecting performance, and has been tested reliably at 50+ blocks tall.
- Bedrock Specific: This timing relies on Bedrock Edition's observer and torch delay behavior to prevent items from getting stranded mid-tower.





