
Video: Fully Automatic Rocket Crafter | Minecraft Java & Bedrock 26.3 Redstone Tutorial by RexxStone
How to build it
- Place the Two Crafters
Clear a 3x4 area that is 3 blocks tall. At the front layer, place one Crafter on the right side facing left, and leave a one-block gap before placing the second Crafter on the left side facing forward (outward).
- Add the Paper Buffer Hopper
In the one-block gap between the two Crafters, place a hopper feeding directly into the side of the front-facing (left) Crafter. The right Crafter will shoot crafted paper straight into this buffer hopper.
- Build the Paper Observer Loop
Place a solid block behind the buffer hopper with a comparator on top reading from that hopper and pointing backward. Have the comparator point into another hopper, then run an observer out of that hopper into a second observer that powers the right-side (paper) Crafter.
- Install Input Hoppers
Place one hopper directly on top of the left Crafter (for gunpowder input) and another hopper directly on top of the right Crafter (for sugar cane input).
- Wire the Resource Detection Torches
Place a comparator reading from the top gunpowder hopper and another comparator reading from the top sugar cane hopper, both pointing toward the back. Run both comparators into solid blocks, and attach a redstone torch to the side of each block so they monitor item levels.
- Construct the Hopper Clock
Behind the left Crafter, place a solid block on the floor with a comparator on top facing into the Crafter. Behind that comparator, place two hoppers facing directly into each other to create a fast hopper clock, and place a single piece of redstone dust on top of the hopper adjacent to the torches.
- Configure the Crafter Slots
Open the right Crafter (paper), disable the top three and bottom three slots so only the middle row of three slots remains open, and fill them with 3 stacks of sugar cane. Open the left Crafter (rockets), disable seven slots so only two remain open, and place 1 stack of gunpowder inside one open slot.
- Prime the Clock and Inputs
Place 1 standard 64-stackable item inside one of the clock hoppers at the back. Finally, put 1 stack of sugar cane into the top input hopper above the paper Crafter to automatically generate the initial paper buffer and start the system.
How it works
This circuit solves the biggest challenge of multi-step auto-crafting—preventing one ingredient from flooding the final Crafter—by splitting the build into two smart subsystems:
- On-Demand Paper Regulation: The right Crafter converts sugar cane into paper and ejects it into the middle buffer hopper. A comparator reads this buffer hopper and locks the hopper behind it. Whenever the buffer hopper completely runs out of paper (and the sugar cane input hopper still has items), both the buffer comparator and the sugar cane check torch turn off. This unlocks the back hopper, causing a state change that the two
Observerblocks detect, firing a pulse into the paper Crafter to restock the buffer with 3 fresh pieces of paper. - AND-Gate Hopper Clock: Two comparators monitor the top input hoppers for gunpowder and sugar cane, inverting their signals through two
Redstone Torchblocks. If either ingredient runs dry, its corresponding torch turns on and powers theRedstone Duston top of the hopper clock, freezing it. When both ingredients are present, both torches turn off, allowing the single item inside the two facing hoppers to bounce back and forth. A comparator reads this rapid oscillation and pulses the rocket Crafter continuously.
Tips & variations
- Flight Duration 1 Only: This ultra-compact design is specifically tuned for Flight Duration 1 rockets (1 gunpowder + 1 paper), which are the most efficient rockets for everyday Elytra travel.
- Pre-filling is Mandatory: Do not skip pre-filling the paper Crafter with 3 full stacks of sugar cane and the rocket Crafter with 1 full stack of gunpowder before hooking up your farms. This guarantees that incoming items stay locked in their proper slots.
- Java & Bedrock Compatibility: Because it relies purely on comparator locks, hopper clocks, and observer block updates rather than quasi-connectivity, this build works identically in both Java and Bedrock Editions.





