
Video: Minecraft Bedrock, How To Build A Hopper Clock by Minecraft How To
How to build it
- Clear a 2x6 Building Area
Find or clear a flat 2-wide by 6-long space for your clock. In the center of one of the 6-block rows, place a temporary solid block.
- Connect the Two Hoppers
Crouch and place your first hopper facing directly into the side of the temporary block. Break the temporary block, then crouch and place the second hopper facing directly into the first one so their nozzles connect in the middle.
- Place the Redstone Comparators
Stand on top of or next to the hoppers and place one redstone comparator facing outward from the left hopper, and another facing outward from the right hopper.
- Add Solid Blocks
Place a solid building block (such as stone bricks or concrete) directly in front of each comparator so the comparators feed their signals into the blocks.
- Place the Redstone Dust
Move to the second row of your 2x6 area and place one piece of redstone dust directly beside each of the two solid blocks.
- Install the Sticky Pistons
Next to each piece of redstone dust, place a sticky piston facing inward toward the center of the build. The two sticky pistons should be facing each other with a 2-block gap between them (right alongside the two hoppers).
- Place the Block of Redstone
Place your Block of Redstone directly in front of either the left or right sticky piston so that it sits adjacent to one of the hoppers.
- Add Items to Set the Timer
Open one of the hoppers and place your chosen number of items inside (anywhere from a few items up to 5 full stacks). The clock will immediately start cycling back and forth.
- Take an Output or Invert the Signal (Optional)
You can take a direct output from the Block of Redstone or the redstone dust at the ends. If you want the output to stay OFF by default and only pulse ON briefly when the clock switches, place a solid block next to one of the redstone dust pieces and attach a redstone torch to that block.
How it works
This circuit is the classic Etho hopper clock, utilizing item transfer rates and piston locking mechanics:
- Hopper Locking: The
Block of Redstonesits next to one of the hoppers, locking it so it cannot push items out, while the unlocked hopper freely transfers its items into the locked one. - Comparator Detection: As long as the transferring hopper still has items, its
Redstone Comparatoroutputs a signal into the solid block, powering the adjacentRedstone Dustand keeping that side'sSticky Pistonextended. - Switching Sides: The moment the unlocked hopper completely empties, its comparator turns off, causing the extended sticky piston to retract. Simultaneously, the other hopper is now full of items, so its comparator and sticky piston are powered—pushing the
Block of Redstoneto the opposite side and reversing the cycle.
Tips & variations
- Adjusting the Speed: Fewer items equal a faster clock; more items equal a slower clock. You can load up to 5 stacks (320 standard stackable items) into a single hopper.
- Signal Inversion: Because the comparator stays on while items are draining, the end redstone dust is powered most of the time and only turns off briefly during the piston switch. Placing a solid block with a Redstone Torch on it next to the end dust inverts this into a short ON pulse instead.
- Common Mistake: Make sure both hoppers are actually pointing into each other (their bottom funnels should connect horizontally). If one points into the ground, the items will get stuck.





