
Video: Easy HOPPER CLOCK TUTORIAL! | How To Build A Hopper Clock by wattles
How to build it
- Connect the Two Hoppers
Place one temporary hopper into the ground, then crouch (hold Shift) and place a second hopper feeding directly into the side of the first one. Break the first hopper, crouch again, and replace it so its nozzle points into the second hopper. Both hoppers should now face directly into each other.
- Place the Comparators
Place one Redstone Comparator on each outer side of the two hoppers. Make sure the single torch (the tip of the triangle) points away from the hoppers so they read the hopper inventories.
- Add the Repeaters
Directly in front of each comparator, place a Redstone Repeater facing the same outward direction to boost the comparator signal.
- Run the Redstone Dust Lines
From the output of each repeater, place 3 Redstone Dust to wrap the wire around toward the parallel space directly beside the hoppers and comparators. Mirror this exact 3-dust path on both sides.
- Install the Sticky Pistons
At the inner end of each 3-dust line, crouch and place a Sticky Piston facing inward toward the other side, with a 2-block gap between the two piston faces right next to the hoppers.
- Place the Block of Redstone and Add Items
Place your Block of Redstone against the face of one of the sticky pistons (directly adjacent to one of the hoppers). Finally, drop your chosen number of stackable items into one of the hoppers and run your output redstone dust from either Position of the redstone block.
How it works
This circuit works by using a Block of Redstone to lock one hopper while allowing the other to drain:
- Hopper Locking: The Block of Redstone sits directly next to one of the two hoppers. A powered hopper cannot push items out, but it can still receive items pushed into it by the unpowered hopper.
- Signal Detection: As items flow from the unpowered hopper into the locked hopper, the Redstone Comparator reading the draining hopper outputs a signal into its repeater, keeping its Sticky Piston extended.
- State Switching: Once the draining hopper becomes completely empty, its comparator turns off and its sticky piston retracts. Meanwhile, the full hopper on the other side has already extended its sticky piston, shifting the Block of Redstone over to lock the newly filled hopper and unlock the empty one.
- Repeating Cycle: The items now flow in the opposite direction, endlessly shifting the Block of Redstone back and forth at an interval determined by the total number of items inside.
Tips & variations
- Adjusting the Speed: Add more items to the hoppers to make the clock cycle slower, or remove items to make it cycle faster. Each item adds roughly 0.4 seconds to each half-cycle.
- Short Pulse Output for Farms: The Block of Redstone stays in place for the entire duration of a transfer cycle. If you want a quick pulse to fire a harvesting piston (like in a sugar cane farm) rather than keeping the piston extended half the time, place an Observer watching one of the redstoneblock positions or dust lines.
- Use Cheap Stackable Items: Always use common items that stack to 64 (such as cobblestone, dirt, or wood planks) for consistent timing.
- Even Shorter Footprint Variant: The traditional Etho hopper clock replaces the repeaters and 3-dust loops with solid blocks and single redstone dust, reducing the footprint to 2x1x6 while working on the same principle.





