Simple TNT World Eater

This vertical TNT flying machine—nicknamed the "Crater Creator"—drops a synchronized grid of TNT to excavate an entire 16x16 chunk straight down to bedrock in just a few minutes. It is ideal for clearing out slime chunks or massive quarry perimeters in Minecraft Bedrock Edition without spending days mining stone and deepslate by hand.

TNT & CannonsIntermediateBedrock Edition
Simple TNT World Eater video tutorial

Video: Minecraft Bedrock: EASY TNT WORLD EATER! Instant Hole Mining Machine! MCPE Xbox PC Switch by silentwisperer

How to build it

  1. Prepare the Area and Pillar Up

    Clear any trees or surface water from your chosen 16x16 chunk and find the center 2x2 blocks (the southeast block works best). From the highest surface block in the area, pillar up 80 temporary blocks into the sky, then drop down 3 blocks so the dispensers will sit 76 blocks above the ground.

  2. Place the Center Dispenser

    Build a 4-block temporary pillar on your starting platform and attach a slime block to its back face. Break the pillar, place an observer facing upwards under that slime block (observing the slime block), and place a downward-facing dispenser directly beneath the observer.

  3. Build the Main Push Wing

    Using temporary blocks, position a downward-facing regular piston next to the center slime assembly and place a slime block on top of that piston. Extend 2 slime blocks to the left and 2 slime blocks to the right to form a 5-block wide horizontal bar.

  4. Add the Outer Wing Pistons

    At both the left and right ends of your 5-block slime bar, place an upward-facing observer directly underneath the end slime block. Place a downward-facing regular piston directly underneath each of those two observers.

  5. Construct the Side Slime Frames

    Below each outer wing piston, use a temporary block to leave a 1-block gap, then place a slime block directly beneath the gap. Attach 2 more slime blocks extending inward toward the center line of the machine on both sides.

  6. Install the Front Corner Dispensers

    On the front face of both side slime frames, extend 3 slime blocks forward. Under the tip of each 3-block arm, place an upward-facing observer with a downward-facing dispenser directly underneath it.

  7. Install the Back Corner Dispensers

    On the back face of both side slime frames, extend 2 slime blocks backward. Under the end of each 2-block arm, place an upward-facing observer and a downward-facing dispenser beneath it to complete the 5-dispenser X-pattern.

  8. Build the Vertical Engine Core

    Return to the top center of the machine and pillar up 3 temporary blocks. Place a downward-facing sticky piston at the top with a slime block underneath it, and place a downward-facing regular piston adjacent to it to push the main frame.

  9. Add the Engine Observers and Trigger

    Place an outward-facing observer and 2 slime blocks alongside the engine pistons, followed by another downward-facing regular piston and a slime block. Place your trapped chest (for manual stepping) or target block (for automatic mode) on the top trigger spot, then add the final sideways observer to link the central piston.

  10. Load the TNT and Remove Scaffolding

    Calculate how many blocks down you want to dig (around 120 to 200 TNT per dispenser to reach bedrock depending on starting elevation) and load an equal amount into all 5 dispensers. Break your 80-block temporary pillar and any leftover scaffolding blocks.

  11. Operate the World Eater

    Open the trapped chest repeatedly to step the machine down 1 block at a time while checking for water or lava pockets, or replace it with a target block and shoot an arrow into it to run the bomber continuously.

How it works

This machine works by combining a vertical downward-moving slime block flying machine with an X-shaped TNT bombing array:

  • Triggering the Engine: Opening the trapped-chest (or hitting the target block with an arrow) creates a block state update detected by the top engine observer.
  • Stepping Downward: The engine's piston pushes the central slime structure down by one block, while the sticky-piston gets pulled along and fires to advance the trailing half of the engine.
  • Wing Synchronization: When the central 5-wide slime bar moves down, the upward-facing observers on the left and right tips detect the movement and fire their downward-facing pistons, pushing both outer dispenser wings down one block in sync.
  • Mid-Air TNT Detonation: Every time the 5 dispenser arms shift downward by one block, the upward-facing observer above each dispenser pulses and drops one ignited tnt. Because the machine starts 76 blocks above the terrain, the falling TNT explodes right at surface level, maximizing blast radius across the 16x16 footprint without leaving pillars behind.

Tips & variations

  • Manual vs. Automatic Mode: Use the Trapped Chest in unscouted terrain so you can pause and clear water or lava sources by hand. If you already know the chunk is dry, swap the chest for a Target Block and shoot an arrow into it; the arrow keeps pulsing the machine automatically until you pick the arrow back up or break the target.
  • Why 76 Blocks High? Dropping TNT from 76 blocks above the ground causes it to detonate right above the floor, breaking roughly 40+ stone or 50+ deepslate per TNT. Dropping it any higher causes harmless mid-air explosions, and dropping it lower reduces the crater spread.
  • TNT Calculation: The bomber uses 1 TNT per dispenser for every Y-level excavated. Take your starting ground Y-level and add 59 (to reach Y = -59 bedrock). For example, starting at Y = 64 requires 64 + 59 = 123 TNT inside each of the 5 dispensers (615 TNT total).
  • Unsticking the Machine: Never let the slime blocks touch natural terrain or trees, or the piston push limit (12 blocks) will stall the wing. If an arm gets stuck, break the obstructing block and place a temporary button on the top of that wing's observer to manually step it back into alignment.
  • Larger 25x25 Variant: You can expand this exact mechanism by adding additional slime wing extensions to hold 13 dispensers in a wider diagonal checkerboard grid to excavate a 25x25 crater.

Frequently asked questions

How much TNT do I need to dig all the way to bedrock?
You need 1 TNT per dispenser for every vertical block you want to dig. From a standard flat surface at Y=64 down to Y=-59, put about 123 TNT into each of the 5 dispensers (615 TNT total).
How do I stop the world eater when using the automatic target block?
Fly up to the top of the machine and either pick up the arrow stuck in the target block or break the target block itself.
What happens if the TNT hits water or lava?
TNT explosions will not destroy blocks submerged in water or lava. You should pause the machine, fly down to sponge or bucket out the liquid sources, and then resume bombing.
Why do I have to build it 80 blocks in the air?
Building 80 blocks up places the dispensers 76 blocks above the ground, which times the 4-second TNT fuse so the TNT explodes right at ground level for maximum block destruction.

Components used

More tunnel bore / quarry