
Video: EASIEST 26.1+ TUNNEL BORE TUTORIAL in Minecraft Bedrock (MCPE/Xbox/PS4/Switch/PC) by JC Playz
How to build it
- Clear the Starting Chamber
At your desired mining depth, dig out a starting room that is 7 blocks wide, 17 blocks long, and 6 blocks tall. This gives the machine plenty of room to sit off the ground and ensures the first TNT blast doesn't blow up the machine itself.
- Start the Elevated Base
Go to the front wall (the direction you want to mine), start at the front-left corner, count 3 blocks to the right, and move 2 blocks backward. Place two temporary solid blocks stacking up, break the bottom one so the top block is floating one block off the floor, and attach a slime block to it.
- Place the Launch Piston and Observer
Attach a regular piston to the slime block facing forward toward the mining wall. Place an observer alongside it with its top arrow pointing forward, then place a second regular piston in front of that observer, also facing forward.
- Install the Upward TNT Dispenser
Place your dispenser next to the front assembly, making sure the dispenser mouth is facing straight up. Next, crouch and place an observer facing into the front regular piston so its top arrow points directly at the piston.
- Add the Rear Sticky Piston Engine
Attach another slime block behind the front module, then use two temporary solid blocks to position a sticky piston behind it facing backward (toward the rear of the machine). Break the two temporary blocks and place a slime block directly in front of the sticky piston's face.
- Build the Rear Slime Wing and Riding Platform
Move to the side of the rear slime block and attach an L-shaped cluster of three more slime blocks (two out to the side, one behind). Place two solid blocks onto the back of these slime blocks to create a safe platform to stand on while operating the bore.
- Attach the Trapped Chest Trigger
Use a temporary block to place the third observer at the rear so its top arrow points forward into the slime block. Break the temporary block, then crouch and place a trapped chest right behind the observer—make sure it is a trapped chest and not a normal chest.
- Build the Boom Arm and Blast Shield
Extend an arm forward from the front slime assembly: place two temporary solid blocks, replace the first with a glowstone block for mobile lighting, then extend four solid blocks forward followed by a second glowstone block. Finish the tip of the arm by placing two ancient debris blocks at the very front to shield the machine from the TNT blasts.
- Load TNT and Operate the Bore
Fill the dispenser with as much TNT as you want to use. To fire a shot, stand on the solid riding block near the back and open the trapped chest once; the chest will automatically close as the bore shifts one block forward and flings a lit TNT ahead of the ancient debris shield. Always wait for the TNT to explode before opening the chest again.
How it works
This tunnel bore relies on a Bedrock Edition feature where tile entities—such as dispensers and trapped chests—can be pushed by pistons.
- Triggering the Cycle: When you open the
trapped-chest, it emits a weak redstone signal and creates a block update detected by the rearobserver. - Stepping Forward: The rear observer powers the main
piston, pushing the front half of the slime machine (including the dispenser and the long ancient debris boom arm) one block forward. Because the trapped chest is moved during this step, your chest UI closes automatically. - Pulling the Rear & Launching TNT: As the front assembly moves, the middle
observerdetects the movement and triggers the rearsticky-pistonto pull the back half of the machine forward. Simultaneously, the front observer fires thedispenserupward into the moving slime/piston stream, launching the ignited TNT straight over the front arm. - Blast Protection: The TNT lands just ahead of the two
ancient-debrisblocks. Since ancient debris is blast-resistant and immovable by explosions, it absorbs the blast standing between the TNT and the fragile redstone components behind it.
Tips & variations
- Wait Between Shots: Never spam-open the trapped chest. Always wait for the launched TNT to detonate before triggering the next step, or you risk pushing the machine directly into a live explosion.
- Clear Liquids Immediately: Water and lava stop TNT from destroying blocks and can flow back into the bore. Whenever you blast into a pocket of lava or water, walk up and plug the source blocks before firing again.
- Keep the Slime Clear: Do not place any blocks directly underneath the machine or touching the slime blocks, or the flying machine will exceed the 12-block piston push limit and jam.
- Bedrock Exclusive: This specific design only works in Minecraft Bedrock Edition because Java Edition pistons cannot push dispensers or trapped chests.


