
Video: How To Make A Perimeter in 1.19 Minecraft Using TNT Quarry's by Shulkercraft
How to build it
- Choose and Mark the Perimeter Location
Select the area for your farm or megabase and mark out the full square or rectangular border on the surface. Try to avoid massive lava lakes or rugged terrain extremes if possible to minimize manual cleanup.
- Prepare the Surface Area
Clear out tall surface obstructions, trees, and structures inside the boundary so the flying machine has a level path to travel across. Drain or fill in surface water bodies so water does not flow into the blast zone and neutralize the TNT.
- Dig Trenches for Flat Walls (Optional)
If you want clean, smooth perimeter walls, dig narrow vertical trenches down along the outer edges of your marked boundary before running the quarry. Clear liquids from these border trenches so the blasts stay contained and leave flat sides.
- Build the Quarry Return Stations and Borders
At the two opposite ends of the perimeter where the flying machine will bounce back and forth, construct the stopper and return trigger stations at the appropriate height above the ground.
- Construct the Flying Machine Engine
Using slime blocks, observers, and sticky pistons, assemble the two-way flying machine engine next to your starting station. Ensure none of the slime blocks touch the ground or unintended immovable blocks.
- Attach the TNT Duper Modules
Build the TNT duplication rigs onto the slime block wings using TNT, dead coral fans, walls, detector rails, and minecarts. Prime the dupers carefully so the TNT updates without igniting prematurely while building.
- Launch and Monitor the TNT Quarry
Trigger the initial observer to start the flying machine. As it sweeps back and forth across the perimeter, patrol the blast zone with building blocks or sponges to plug any underground water or lava pockets exposed in the walls or floor.
- Clean the Sides and Bedrock Floor
Once the quarry reaches bedrock level and finishes blasting, dismantle the flying machine. Clean up any remaining jagged blocks along the perimeter walls and remove leftover stone ridges around the bedrock floor.
How it works
A perimeter TNT quarry combines a two-way slime block flying machine with TNT duper modules to systematically excavate large volumes of terrain:
- Propulsion Engine: Observers detect block movement and power pistons and sticky pistons in an alternating push-pull cycle, moving the entire slime structure horizontally across the perimeter one block at a time.
- TNT Duplication: Each movement cycle pushes a priming assembly (consisting of a
detector-rail, minecart, wall, anddead-coral-fan) adjacent to atntblock. Through Java Edition piston update mechanics, a lit TNT entity is spawned and drops down while the original TNT block remains intact in the frame. - Return Mechanism: When the machine hits the stopper station at the far edge of the perimeter, an observer or piston circuit triggers the reverse engine, sending the bomber back across the trench to continuously lower the floor down to bedrock.
Tips & variations
- Java Edition Only: TNT duplication relies on update order and piston mechanics exclusive to Minecraft Java Edition; this quarry will not duplicate TNT on Bedrock Edition.
- Liquid Control is Critical: Flowing water completely stops TNT block damage. Keep blocks and sponges in your hotbar while the quarry runs so you can immediately seal off underground aquifers and lava lakes.
- Chunk Loading: Never unload the chunks or walk too far away while the flying machine is moving, or the pistons and entities can desynchronize and blow up the machine itself.
- 1.19+ Depth: Because world generation goes down to Y=-64 and deepslate has higher blast resistance than stone, the quarry will need significantly more passes than in pre-1.18 versions.


