
Video: Minecraft Bedrock Edition Armor Stand Critout Trap by Reality
How to build it
- Build the Drop Tube Base
Place a single bottom slab on the ground to act as the landing floor of your drop chute. Surround this slab with crafting tables and build the walls up a few blocks high to form a 1x1 vertical shaft.
- Install the String Detector
Break one crafting table near the bottom of the tube and replace it with a regular piston facing inward. Place a piece of string inside the tube directly above that piston, and put an observer facing the string to detect falling players.
- Wire the Delay Circuit
Behind the observer, build a small platform of solid blocks to support your redstone line. Run redstone dust from the observer into two repeaters—one set to 4 ticks and the other set to 2 ticks—and place a downward-facing sticky piston next to the end of this dust line.
- Set Up the Front Sticky Pistons
Move to the front side of the wiring and place two vertically stacked sticky pistons facing the drop chamber. Place a solid block with redstone dust on top next to them so they are ready to receive power.
- Create the Clipping Chamber
Underneath the crafting table opposite the pushing piston, place a cobblestone wall. Arrange top slabs in front of it and place a fence post alongside it, surrounding the exterior with additional crafting tables and a solid block to form the tight pocket where the player will be pinned.
- Build the Torch Tower & Lower Wiring
Place a redstone torch underneath the side solid block and build a vertical torch tower upward using blocks, redstone torches, and redstone dust. Dig underneath the initial inward-facing piston and run an L-shaped line of redstone dust to connect the lower piston to the circuit.
- Block Placement Prevention
Inside the lower drop tube, place a fence gate and open it so players fall right through. Line the upper interior walls of the shaft with signs so trapped victims cannot place blocks to save themselves.
- Load and Align the Armor Stands
Temporarily remove the four upper crafting tables around the holding cell and set up three regular pistons with a lever. Drop batches of about 20 armor stands onto a temporary block, use the pistons to push them into the back corners and sides, then break the block so roughly 80 to 100 armor stands fall into the chamber.
- Dispense the Chest Minecarts
Place a temporary block above the armor stand chamber with a rail on top and a dispenser facing the rail. Power the dispenser using a temporary two-observer clock to stack up to 100 chest minecarts onto the rail, then break the temporary block so the minecarts drop onto the armor stands.
- Seal the Trap and Create the Kill Window
Remove the temporary dispenser setup and rebuild the upper drop shaft using crafting tables and interior signs. Finally, dig a small access area below the clipping chamber where you can safely look up and strike the trapped player's feet.
How it works
This trap abuses entity hitboxes and block alignment in Minecraft Bedrock Edition to completely disable a player's controls:
- Trigger Detection: When a victim falls down the 1x1 crafting table shaft, they pass through the string. The
observerdetects the string state change and sends a redstone pulse into the repeater delay line. - Player Clipping: The pulse triggers the pistons in sequence, shoving the player off the bottom slab and pinning them tightly between the fence post, cobblestone wall, and top slabs.
- Input Interception: Because the player's head is clipped directly inside the dense stack of 80–100 armor stands and chest minecarts, every click or tap they make interacts with an armor stand inventory or chest GUI instead of consuming food, throwing an ender pearl, or swinging a tool.
- Safe Elimination: With the victim immobilized and unable to heal, the trap owner can stand beneath the floor slabs and repeatedly jump-attack (crit out) the exposed bottom of the player's hitbox.
Tips & variations
- Why Crafting Tables? The interior walls are lined with crafting tables and signs so that even if a player clicks past the entities, they merely open the crafting UI rather than placing blocks or using items.
- Entity Count vs. Lag: Using roughly 100 armor stands and 100 chest minecarts makes it practically impossible for a victim to break through them in time, though you can reduce the count to 50–80 of each on lower-end devices to keep framerates smooth.
- Bedrock Exclusive: This specific layout is adapted from Java Edition concepts but relies on Bedrock Edition's piston pushing, entity collision, and hitbox alignment mechanics.





