
Video: 5x1 Flatground Tutorial! by Sharp and Shadow
How to build it
- Choose a Location and Dig the Entry
Find a flat area, ideally next to a tree or natural obstacle so targets cannot easily run around the trap. Count three blocks out from the obstacle, dig down three blocks, and cover the ceiling above you to stay hidden.
- Excavate the Main Trench
From your starting hole, dig two blocks out to both the left and right sides to create a 5-block-wide trench, then clear one block forward.
- Wire the Double Piston Extender Base
Dig out the lower rows for the vertical double piston extender and lay down lines of redstone dust. Place observers facing upwards over the dust to trigger the final retraction pulse, and place a redstone torch on the side to power the resting state.
- Set Up the Repeater Timing
Behind the assembly, place a redstone repeater set to 4 ticks. Place a solid block, jump to place a second repeater at the proper orientation, and connect the gap with redstone dust.
- Run the Trigger Line
Leave a one-block gap away from the observer so the wire does not accidentally connect, then dig a tunnel 5 blocks back toward your pull spot. Cover the floor of this tunnel with redstone dust and mark the surface spot above the end of the line so you know where to place your lever.
- Install the Sticky Pistons
Connect the trigger line to the repeater and redstone torch. Jump and place the vertically facing sticky pistons for the double piston extender, plus an additional vertical sticky piston right above the redstone torch.
- Clear Surrounding Blocks and Add Furnaces
Clear out all adjacent stone or dirt around the 5-block row so the slime blocks will not stick to the walls. Place two furnaces (or other immovable blocks) in the side gaps so falling players cannot land safely on a ledge.
- Place Slime Blocks and Final Piston
Place a row of 5 slime blocks (or honey blocks) across the top of your extender. Break the stone at the end to install an observer, a piece of redstone dust, and a final sticky piston to complete the mechanism.
- Dig the Drop Chute and Test
Dig out the lethal drop chute below the retraction zone and place signs or banners along the inner lip so players cannot catch themselves or place blocks. Return to the surface, place a lever at your marked pull spot, and toggle it to test the opening and closing.
How it works
This trap relies on a vertical double piston extender paired with a 5-block slime or honey bar to keep the mechanism completely flush with the flat ground above:
- Resting (Closed) State: The redstone torch and the 4-tick repeater line keep the vertical sticky pistons extended while the surface lever is off. This holds the 5 slime blocks and the 5 surface blocks right at ground level.
- Opening the Trap: When you flick the trigger lever on the surface, the redstone dust line deactivates the redstone torch and depowers the repeater circuit in sequence. The top sticky pistons retract first, pulling the grass blocks down, and the bottom pistons retract immediately after.
- Observer Cleanup Pulse: As the assembly shifts downward, the upward-facing observers detect the state change and fire a short upward pulse into the lower sticky pistons, completing the double retraction and pulling the floor completely out of the way so the target falls straight into the pit.
Tips & variations
- Slime vs. Honey Blocks: You can substitute the 5 slime blocks with 5 honey blocks if you want to save slime for other PvP tools.
- Preventing Block Sticking: Always double-check that every block touching the 5-block slime row (other than the floor blocks being pulled and the pistons below) is either air or an immovable block like a furnace. One stray dirt block will exceed the push limit or jam the extender.
- Adjusting Repeaters While Sneaking: If you use toggle sneak while hiding underground, remember that right-clicking a repeater with an item in your hand will not change its delay—use an empty hand or un-sneak momentarily to set the 4-tick repeater.





