
Video: Minecraft: Silent Dual Edge Detector (4x4x3) by Xaptrosity | Gaming, Minecraft & MORE!
How to build it
- Lay the Base Blocks
Start by placing your solid building blocks in a 2x3 rectangle on the ground to form the main foundation of the circuit.
- Add the Initial Repeaters
Place redstone repeaters feeding into the starting block formation, and run a line of redstone dust around the back to connect the paths.
- Connect the Secondary Repeater and Blocks
Route the rear redstone line into another repeater that points directly into a few additional building blocks at the back of the build.
- Place the Redstone Torches
Attach a redstone torch to the output block, and place a second redstone torch on the back (or the side) of the rear block structure to invert the signal.
- Adjust the Repeater Delays
Set the two main delay repeaters in the circuit to 4 ticks each (fully dragged back) so the timing offset generates a pulse on both state changes.
- Attach the Input Lever
Place your lever on the front input block. Flipping it either on or off will now send a quick 1-tick pulse through the output.
How it works
This circuit functions by splitting the input signal from the lever into parallel paths with different timings using repeaters and redstone torches:
- Rising Edge (Turning On): When the lever is switched on, the direct path and the 4-tick delayed repeater path change states at slightly different moments. Because one path is inverted with a redstone torch, there is a brief 1-tick window before the delayed signal catches up, allowing the output to flash on and immediately turn back off.
- Falling Edge (Turning Off): When the lever is switched off, the exact opposite delay occurs. The fast path depowers immediately while the 4-tick repeater holds the secondary torch off just long enough to let another 1-tick pulse escape.
- Silent Operation: Because the logic relies entirely on torch inversion and repeater delays rather than moving blocks, it makes zero piston noise.
Tips & variations
- Torch Placement: The secondary redstone torch at the back can be placed either on the back face or the side face of its block depending on how you want to route your wiring.
- Common Mistakes: If your output stays permanently on or fails to pulse on one of the edges, double-check that both timing repeaters are set to their maximum 4-tick delay.
- Modern Alternatives: In newer versions of Minecraft, an
Observerwatching a redstone dust line provides a 1-block silent dual edge detector, though this torch-and-repeater circuit remains great for old-school survival or when you lack Nether Quartz.





