
Video: Minecraft - Dual Edge Trigger (Without a BUD) by xRush101
How to build it
- Stack the Input Blocks
Start a 1-block-wide build by stacking two solid building blocks on top of each other to form the input column.
- Attach the Redstone Torches
Place a redstone torch on both of the stacked solid blocks.
- Run the Redstone Dust Line
Place a line of redstone dust leading down from the torches and dipping into a 1-block hole in the ground.
- Place the Upper Block and Downward Piston
Place a solid block (such as wool) on top of the structure, and attach a regular or sticky piston to it facing downward.
- Connect Input and Output
Attach your input device (such as a lever or pressure plate) to the front of the stacked blocks. Take your pulse output from the end of the circuit where the piston and redstone line meet.
How it works
A standard dual edge detector emits a brief pulse whenever a signal transitions from OFF to ON (rising edge) or from ON to OFF (falling edge).
- No BUD Interference: Traditional dual edge triggers often rely on Block Update Detectors (BUDs), which can accidentally trigger whenever nearby redstone dust changes state. This design uses direct redstone torch and piston timing instead.
- Rising & Falling Detection: When the input (such as a lever) is flipped ON, the two redstone torches and the downward-facing piston change states at slightly different delays, creating a brief window where a pulse passes through the redstone line dipping into the hole.
- Resetting: When the input is flipped OFF, the torches and downward piston revert in the opposite order, generating a second short pulse at the output.
Tips & variations
- 1-Wide Profile: Because the entire build is only one block wide and does not rely on BUD mechanics, it is much safer to fit next to other redstone wires in tight contraptions.
- Piston Choice: The video notes that you can use either a regular piston or a sticky piston for the downward-facing piston depending on how your block/dust cutoff is arranged, plus any piston or lamp at the output to test the pulse.
- Versatile Inputs: Try pairing this with a lever to make it act like a button, or hook it up to a pressure plate to trigger a pulse once when a player steps on it and again when they step off.





