
Video: How to Build a Block Swapper in Minecraft. *EASY* by CowCapz
How to build it
- Build the Support Frame
Place a temporary dirt block on the ground. Attach two solid building blocks extending from it, then place one more solid block going backward to create a small frame.
- Place the First Sticky Piston
Set a sticky piston on top of the frame block so that it faces the spot where your swapped block will be displayed.
- Add the Redstone Torch
Break the temporary dirt block and put a redstone torch in its place attached to the frame.
- Wire the Redstone Dust
Place one piece of redstone dust directly underneath the block structure and a second piece of redstone dust beside it to carry the signal.
- Place the Second Sticky Piston
Position your second sticky piston next to the redstone line, facing perpendicular to the first sticky piston so both pistons aim at the same display spot.
- Attach the Lever and Swap Blocks
Place a lever on the front of the frame to power the circuit, place your two swappable blocks in front of the sticky pistons, and cover the rest with wall blocks.
How it works
This block swapper works by inverting the power states of two perpendicular sticky pistons aimed at the same intersection block:
- In the default state, the redstone torch is lit, keeping one sticky piston extended while the other remains retracted.
- When you flick the lever, it powers the block holding the redstone torch (turning the torch off) and simultaneously powers the redstone dust line.
- Because a piston retracts faster than a newly powered piston extends, the active sticky piston pulls its block back just before the second sticky piston pushes the alternate block into the display spot.
Tips & variations
- Avoid container blocks in Java Edition: As noted in the build, do not use blocks that store items (such as chests or furnaces) because pistons cannot push tile entities in Java Edition. Use crafting tables, lighting blocks, or decorative blocks instead.
- Hiding the wiring: Once tested, build a solid wall around the pistons so only the front face of the active block and your lever are visible.



