
Video: Infinite Self Building Bridge Tutorial | Minecraft Redstone by Opisek
How to build it
- Place a temporary Obsidian stop block
Start by placing a single Obsidian block at the front where your bridge will begin so the flying machine does not accidentally launch while you place observers.
- Build the front two-way engine
Create the main engine using two Sticky Pistons facing opposite directions with two Slime Blocks attached to each side. Add two Observers configured to trigger the two pistons for forward and backward movement, plus one extra Observer to link to the trailing modules.
- Lay out the repeating observer line
Behind the engine, place a row of Observers spaced out evenly for as many bridge segments as you want to build. You can omit the extra linking observer on the very last module at the back.
- Add slime blocks and sticky pistons for each module
On top of each module observer, place a pair of Slime Blocks with a Sticky Piston placed in between consecutive modules. Because each module pulls the next one independently, this pattern can be repeated infinitely.
- Install the walkway blocks
Place two solid, pushable building blocks on top of the Slime Blocks in every module to form the walking surface. Do not use immovable tile entities or blocks like Obsidian, Furnaces, Hoppers, or Droppers here.
- Build the alternating extension blocks
Alongside the modules, build a stationary line of solid conductive blocks in an alternating pattern: place a solid block one block below every module observer, and place a raised solid block in the gaps between the observers.
- Add 4-tick repeaters along the line
Place Redstone Repeaters inside the gaps between the raised blocks pointing toward the front engine. Set every repeater in this chain to a 4-tick delay so each bridge segment triggers in sequence.
- Place the destination stopping block
Out in front of the bridge at your desired stopping point, place an immovable block like Obsidian (or a row of over 12 blocks) directly in the path of the front engine or walkway.
- Wire the extension and retraction trigger
Connect a Button or Lever to the back of the 4-tick repeater chain to launch the bridge forward when you remove the temporary starting Obsidian. To retract the bridge once it stops at the destination, run a redstone pulse into the rear return observer.
- Optional: Add a spam-proof button lock
If using a single button, split the input into two Sticky Pistons that only connect the circuit when a Block of Redstone carried on the last module arrives at either the start or the end, preventing button spam while the bridge is moving.
How it works
Traditional piston bridges are limited by Minecraft's 12-block push limit, meaning a single piston cannot simply push a long bridge across a gap. This design bypasses that limit by breaking the bridge into independent 2-block modules connected in a caterpillar chain.
- Extension Sequence: When you trigger the input, the signal travels down the stationary line of 4-tick Redstone Repeaters toward the front engine. As the signal passes each solid block beneath a module's Observer, it triggers the segments in a synchronized wave, launching the front engine and every trailing module one step after another until the front hits the Obsidian stop block.
- Retraction Sequence: When the bridge is fully extended, sending a single redstone pulse into the return Observer starts the engine moving backward. As each module pulls back, it updates the observer of the module behind it, pulling the entire bridge back to the starting dock automatically.
Tips & variations
- Walkway Block Choice: You can use almost any regular solid block (Stone, Iron Blocks, Wood Planks) for the bridge floor, as long as it can be moved by pistons and does not stick to neighboring stationary walls.
- Stopping Distance: If you want a single lever or button at the start to control both extension and retraction, make sure the destination Obsidian stop block is placed at a distance where one of the module retraction observers lines up directly with your return redstone wire when fully extended.
- Preventing Breakage: Never press the activation button again while the flying machine is still in transit, or the repeater line will send misfiring pulses into moving modules and break the spacing. Use a lever or build the redstone-block piston gate shown at the end of the video to lock the input during travel.





