
Video: Simple, ADAPTABLE Piston Feed Tape for Minecraft by SuperD2000
How to build it
- Lay Out Your Feed Tape Shape
Build a closed loop of movable blocks in the exact shape you want your feed tape to travel. You can build this horizontally or vertically, and include inward or outward turns, so long as every single straight side is at least 3 blocks long.
- Empty All Corners Except One
Break the corner block on every turn of your shape—including any inside corners—except for one single corner. Leave that final corner block intact so the tape has a block ready to be pushed first.
- Place the First Corner Observer
Pick a flow direction (clockwise or counter-clockwise) and go to your first turn. Place an observer whose face looks directly at the empty corner space, with its red output dot pointing outward away from the track.
- Add the Second Observer and Piston
Place a second observer detecting the output of the first observer, routing the signal around the corner. Place a regular piston at the output dot of the second observer so the piston head faces down the next line of blocks in your chosen travel direction.
- Repeat the Module on Every Turn
Build this exact same 2-observer, 1-piston module on every remaining outside and inside turn of your loop. Double-check that every piston pushes blocks in the exact same rotational direction around the track.
- Start the Piston Feed Tape
Find the one corner where you left the corner block intact directly in front of a piston. Quickly break and replace the block next to that module's observer (or update the observer face directly) to trigger the first push and start the continuous loop.
How it works
This circuit relies entirely on a chain reaction of block updates rather than an external redstone clock:
- Corner Detection: Each turn in the loop leaves an empty corner space monitored by the face of the first
observer. - Signal Delay and Routing: When a piston pushes a line of blocks forward, a block enters the empty corner spot across from it. The first
observerdetects this block arriving and sends a 1-tick pulse into the secondobserver. - Pushing the Next Side: The second
observeradds a brief delay and powers the adjacentpiston, pushing that newly arrived corner block down the next segment of the track and into the next corner's detector. - Continuous Loop: Because one corner starts filled while all other corners are empty, the empty gap travels backward as the blocks shift forward, creating a self-sustaining cycle.
Tips & variations
- 3-Block Minimum Rule: Every straight segment of your shape must be at least 3 blocks long. Any shorter and the 2-observer, 1-piston corner modules will collide with each other, especially on inside turns.
- Vertical Builds: Because observers and pistons are fully omnidirectional, you can build this exact same layout vertically. Just make sure the first observer watches the corner spot and the second observer directs its output dot into the back of the piston.
- Direction Check: The most common mistake is accidentally mirroring a corner module so two pistons push against each other. Trace the loop with your crosshair before starting it to verify every piston points the same way around the path.
- Piston Push Limit: Keep each straight side within the standard 12-block piston push limit so the pistons do not jam.





