
Video: 2x2x3 BEST Multifloor Realistic Elevator | Minecraft 26.1 Redstone Tutorial by BLag
How to build it
- Build the 2x2x3 Elevator Cabin and Engine
Start at the bottom of your elevator shaft and construct the flying machine engine using alternating slime blocks and honey blocks so the segments can move together without exceeding the piston push limit. Attach the 2x2 floor and the 3-block-high cabin frame on top of the engine, lining the shaft walls with immovable or non-stick blocks so the carriage slides freely.
- Install the Elevator Doors
At each floor opening along the 2x2 shaft, build the doorway frame and wire the automatic door mechanism. Ensure the door pistons sit flush when closed and retract completely out of the path of the moving slime and honey blocks when the cabin is in transit.
- Wire the Send Up Circuit
Behind the cabin controls at the lower floor, place an input button and route a redstone line to the bottom upward-facing observer of the flying machine. Triggering this line updates the engine to begin pushing the 2x2x3 cabin upward.
- Wire the Send Down Circuit
Set up a second button line for downward travel that sends a redstone pulse to the top downward-facing observer of the engine. When activated at an upper floor, this reverses the flying machine and pulls the cabin down the shaft.
- Build the Stop Up Mechanism
At each destination floor above the ground level, install a stopping mechanism using an immovable block or extendable piston brake positioned to catch the upward-moving engine. Align it carefully so the cabin floor stops completely flush with the hallway floor.
- Build the Stop Down Mechanism
Add the downward stopping mechanism at the lower and intermediate floor levels to intercept the descending flying machine. Once both stop circuits are in place, test calling and sending the elevator between all floors to verify that the doors and brakes synchronize properly.
How it works
This multi-floor elevator operates by combining a two-way vertical flying machine with floor-level braking and door logic:
- 2x2x3 Cabin Carriage: Because a standard piston can only push up to 12 blocks, the 2x2x3 cabin is divided into adjacent slices of
Slime BlocksandHoney Blocks. Since slime and honey do not stick to each other, multiple sticky pistons and observers can move the full cabin in unison. - Send Up and Send Down Triggers: Two separate pulse lines—Send Up and Send Down—provide an initial block update to either the bottom or top observer of the engine, determining the direction of travel while closing the floor doors.
- Stop Up and Stop Down Brakes: The flying machine continues moving vertically until it encounters an immovable obstacle in the shaft. The Stop Up and Stop Down modules move stopping blocks into the engine's path at the selected floor, halting the observers and pistons so the cabin rests flush with the landing.
Tips & variations
- Java Edition Mechanics: This design is built specifically for Minecraft Java Edition and relies on deterministic piston update timings and quasi-connectivity; it will not work reliably on Bedrock Edition.
- Preventing Stuck Cabins: Double-check that every wall surrounding the shaft is made of non-stick blocks (such as obsidian, glazed terracotta, furnaces, or leaves) wherever exposed slime or honey blocks pass by.
- Chunk Boundaries: Build the entire elevator shaft within a single chunk if possible, and avoid unloading the area while the cabin is moving between floors.




