
Video: Minecraft Bedrock - Redstone Tutorial - Ultimate T-Flip-Flop Tutorial by Dartanman
How to build it
- Place the First Two Droppers
Place your first dropper on the ground facing horizontally into the space next to it. In the spot that the first dropper is pointing into, place a second dropper facing straight up.
- Complete the Dropper-Hopper Loop
On top of the upward-facing dropper, place a third dropper facing back toward the first one. Crouch and place a hopper on top of the very first dropper so the third dropper pushes items into the hopper, and the hopper feeds them back down into the first dropper.
- Attach the Output Comparator
Place a redstone comparator facing away from the back of the first dropper you placed. Place a redstone repeater directly in front of the comparator to boost the signal to full strength, and connect it to a redstone lamp or your contraption.
- Add the Item and Input Button
Toss a single item of any kind into the hopper so it falls into the first dropper below, turning on the comparator and lamp. Finally, crouch and place a button on the middle (upward-facing) dropper, or run your input redstone line directly into that middle dropper to toggle the circuit.
How it works
This T flip-flop stores its on/off state using the position of a single item inside a four-block loop:
- ON State: When the item rests in the first dropper, the
Redstone Comparatordetects it and outputs a weak signal. TheRedstone Repeaterboosts this signal to power level 15, keeping your output turned on. - Switching OFF: Pressing the button (or powering the middle dropper) powers the adjacent first dropper as well, shooting the item into the second (middle) dropper. Because the first dropper is now empty, the comparator turns off.
- Switching ON: Pressing the button a second time powers the middle dropper and the third dropper next to it. The item is pushed into the third dropper, which immediately fires it into the
Hopper. The hopper transfers the item right back into the first dropper, turning the comparator output back on.
Tips & variations
- Flat Horizontal Variant: If you lack vertical room, you can build the exact same 2x2 loop completely flat on the ground. Arrange three droppers and one hopper in a horizontal square loop, take your comparator output from the first dropper that the hopper points into, and power the middle dropper in the chain.
- Dual-Button Piston Doors: If you use a single lever on a piston door, locking it from one side leaves you stuck if you are on the other side. Instead, wire buttons on both the inside and outside of your door into the same redstone line leading into the middle dropper. Either button will now open and close the door.
- Always Use a Repeater: A single item inside a dropper only gives a signal strength of 1 (or 2 if non-stackable) through a comparator, so always place a repeater after the comparator to reach your redstone wire.



