Copper Bulb T Flip-Flop

A T Flip-Flop converts a temporary redstone pulse—like a button press or pressure plate step—into a permanent toggle similar to a lever. With the addition of the Copper Bulb in the 1.21 update, you can now build a reliable T Flip-Flop using just two blocks. It is ideal for toggling piston doors, lighting systems, and farms from multiple locations.

Memory CircuitsBeginnerBedrock Edition
Copper Bulb T Flip-Flop video tutorial

Video: Copper Bulb The Best T-Flop | Let's Learn Redstone 08 | Minecraft Redstone Tutorial by OmLedu

How to build it

  1. Place the Copper Bulb

    Put down a Copper Bulb where you want your circuit located. Any oxidation stage or waxed variant works the exact same way for redstone.

  2. Attach the Redstone Comparator

    Place a Redstone Comparator directly next to the Copper Bulb so that the two back pins are facing the bulb and the single front torch points toward your output.

  3. Connect Your Input

    Place a button diretamente on the Copper Bulb, or run a line of redstone dust from buttons or pressure plates into the bulb.

  4. Wire the Output

    Connect the front of the Redstone Comparator to your door, lamp, or machine. Pressing your input will now toggle the output signal permanently on and off.

How it works

The Copper Bulb has a built-in toggle state that makes older multi-block T Flip-Flops obsolete:

  • State Toggling: Whenever the Copper Bulb receives a redstone pulse, it switches its light state from off to on, or from on to off. It stays in that state even after the input pulse ends.
  • Signal Extraction: A lit Copper Bulb does not power adjacent redstone dust directly. However, when a Redstone Comparator reads a lit bulb, it outputs a maximum redstone signal strength of 15.
  • Resetting: Sending a second pulse to the bulb turns the light off, dropping the comparator's output back to 0.

Tips & variations

  • Reading Through a Block: Just like with containers, the comparator does not have to touch the Copper Bulb directly. You can place a solid building block between the Copper Bulb and the comparator, and the comparator will still read the signal through the block.
  • No Repeater Required: Because the comparator outputs a full signal strength of 15 when the bulb is lit, you do not need a repeater right after the comparator to boost the signal.
  • Multiple Inputs: You can wire as many buttons, pressure plates, or other triggers as you want into the same Copper Bulb to toggle a single machine from different rooms.
  • Common Mistake: Do not place redstone dust directly against the Copper Bulb expecting an output—you must use a comparator to read whether the bulb is lit.
  • Survival Crafting: One craft uses 3 Copper Blocks, 1 Blaze Rod, and 1 Redstone Dust and yields 4 Copper Bulbs.

Frequently asked questions

Does the oxidation level of the Copper Bulb change the redstone signal?
No. While oxidation dims the visual light the bulb gives off, a comparator reading any lit Copper Bulb always outputs a full signal strength of 15.
Why isn't my Copper Bulb powering the redstone dust next to it?
Copper Bulbs do not emit redstone power directly to adjacent dust or mechanism blocks. You must place a Redstone Comparator facing away from the bulb to read its state.
Can a comparator read the Copper Bulb through a wall?
Yes. A comparator can read the Copper Bulb's state straight through one solid block, allowing you to hide the wiring behind a wall.

Components used

More t flip-flop