NOT Gate Inverter

A NOT gate, commonly called an inverter, is the most fundamental logic gate in Minecraft redstone. It takes an incoming signal and reverses it, turning an active current off and an inactive current on. You will use it to keep mechanisms powered by default, extend redstone signals beyond 15 blocks, and fix reversed minecart track intersections.

Logic GatesBeginnerJava Edition
NOT Gate Inverter video tutorial

Video: Redstone Tutorial: NOT Gate by necramar

How to build it

  1. Place the Inverter Block

    Place a single solid building block on the ground where you want your signal to be inverted.

  2. Run the Input Wire

    Lay a line of redstone dust leading directly into the back face of your solid block, and connect the start of the wire to a lever or pressure plate.

  3. Attach the Redstone Torch

    Place a redstone torch on the opposite (front) face of the block. This completes the basic NOT gate.

  4. Connect the Output Wire

    Run redstone dust away from the front of the redstone torch to carry your newly inverted signal to your mechanism.

  5. Optional: Chain Two Gates as a Repeater

    If your redstone line loses power after 15 blocks, place a second NOT gate along the output wire. The first gate inverts and refreshes the signal, and the second gate flips it back to its original state.

  6. Optional: Build the 2-Block Compact Repeater

    For a smaller signal extender, place two blocks side-by-side in line with your wire. Put a redstone torch on top of the first block, redstone dust on top of the second block, and a second redstone torch on the front face of the second block.

How it works

A NOT gate relies on the behavior of redstone torches when attached to powered blocks:

  • Inactive Input -> Active Output: When the input redstone dust is unpowered, the solid block remains unpowered. The redstone torch attached to it stays lit by default, sending a full level-15 signal into the output wire.
  • Active Input -> Inactive Output: When you flip the lever or step on the pressure plate, the input redstone dust strongly powers the solid block. Powering the block attached to a redstone torch forces the torch to turn off, cutting power to the output line.
  • Signal Extension: Because redstone dust only carries current for 15 blocks, each lit redstone torch acts as a fresh power source that can push the signal another 15 blocks. Using two NOT gates in a row flips the signal twice, restoring the original on/off state while resetting the signal strength.

Tips & variations

  • Fixing Inverted Minecart Tracks: Unpowered curved rails naturally align toward the South and West by default. If your button or pressure plate closes a track switch instead of opening it because of the direction you built it, insert a single NOT gate in the redstone line leading to the torch under the track to reverse its default state.
  • Torch Placement Variant: You can also place the redstone torch on top of the block rather than on the front face, depending on where you need your output wire to go.
  • Common Mistake: Make sure the input redstone dust points directly into the block holding the torch. If the wire simply runs past the side of the block without pointing into it, the torch will never turn off.

Frequently asked questions

Why is a NOT gate called an inverter?
It is called an inverter because it flips (inverts) the incoming redstone state: an ON input produces an OFF output, and an OFF input produces an ON output.
How far can a NOT gate extend a redstone signal?
The redstone torch on a NOT gate acts as a brand-new power source, extending the wire's reach by another 15 blocks.
Why does my minecart track switch work backward from a tutorial?
Curved rails have a directional preference toward South and West when unpowered. Placing a NOT gate in the wire between your button or pressure plate and the track's torch reverses the default state and fixes the alignment.

Components used

More not gate